0
Underneath the rear seat (virtually centre of the rear 2 foot wells) you'll you'll find 1* 10mm nuts either side of the centre arch = undo these and putting yours hands behind the seat give it a good hefty pull = seat will (eventually) come out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Peugeot 406 Break How can you remove the panel for replacing the rear speakers?
Undo the 12mm nut from under the speaker in the boot.
How would you remove a starter motor on a Peugeot 406 LX DT?
how do youremove a starter moto on a peugeot 406 please
What size are the rear speakers on a peugeot 406 estate?
10cm
How do you remove a fuel pump peugeot 406 2.0 lx petrol?
Slowly
How do you remove a driveshaft off of a peugeot 406?
This is a complex procedure, get a manual for this vehicle.
How do you release a Peugeot 406 rear centre seat belt that is retracted and stuck tight?
hi,had similar problem,had to unbolt both sides of back of rear seat,to give better angle & gently pull it out, once fixed b4 putting seat down again,pull seat belt out & knot it,which will prevent it happening again
Where the hom on the Peugeot 406 2.0hdi?
WHERE THE HOM ON THE peugeot 406 2.0hdi out sade
Diagram of front suspension on Peugeot 406?
were will i get information for 1996 peugeot 406 petrol
How do you change the ignition coils on a Peugeot 406?
How do you change the ignition coil on a peugeot 406 coupe?
What are the speaker sizes for a Peugeot 406?
Front Speakers: 6.5" Component system Rear Speakers: 6"x9"
How do you replace a heater matrix on a Peugeot 406?
not an expensive job to do. part cost about £10 but apparently it is an awkard job as a part of the dash on passengers side needs removing to get in at it. how do you remove a heater motor from a peugeot 406 do you have to remove the full dashboard or just the glove compartment
How do you remove key stuck in ignition on peugeot 406 hdi?
To remove a key that is stuck in the ignition on a Peugeot 406 HDI, make sure that the car is in park. Then try to remove the key. If this does not work, spray the ignition mechanism with WD-40 after pulling out the key as far as possible. Then work the key in and out until it comes out.
