Want this question answered?
The speaker covers are held in with a screw, remove it and tilt it out away from where the screw was. then remove the screws holding the speaker in and remove the speaker.
5x8 rear 5 1/2 front
Loosen the screws of the lower grill and headlamp assembly so that it can be removed from the fenders. Remove the upper grill fasteners and remove the grill. Take off the headlight housing. Remove the headlamp motor and housing. Take out the headlight. Now the fender can be unbolted and removed.
Remove the cover. Under the cover there is a C-clip. Remove it and the rest comes out.
to get to the speaker you gotta remove the whole door panel. theres a bunch of scews along thr bottom and the side i think then you just gotta pull off the door panel. be careful cuz the door lever gets caught up an theres plastic clips on the back of the panel so try not to break them. once you get the door panel off the speaker is right there in front of you
It is near the right front headlight. You have to remove the grill to access.
If it is like the Country model, carefully pry off the black grills over the speakers. Be careful not to bend the metal prongs on the edges of the grill. Then the speaker is exposed and you will find four screws or "buttons" that you will need to remove in order to get the speaker removed. Once you have the speaker off - just remember solid wire to solid wire; solid with stripe to solid with stripe. Usually the new speaker will have screws to attach the replacement speaker with rather than the "button" type attachment. So, it is easier to remove later for your next set! Match up the metal prongs on the speaker grill cover to the openings in the ceiling and push gently to secure it in place. That's it.
Yes , there was a 1995 full size Ford Bronco ( the last model year was 1996 )
Place the clips in the grill so that they are in their lock position then just push the grill in until they click into place.
Remove the two bolts that hold the whole trim assembly together. Remove the outer trim and turn signal and then the marker lights to change them.
Reverse the process to install the new speakers. You will need to remove the speaker covers from your 1995 Chevrolet rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.
driver's side, under the dash. If you remove the left speaker cover and speaker, you should be able to see it and have access to the removal screws