Insert the tip of your snap ring pliers into the two tiny holes on the left and right hand side of the snap ring. Then press the snap ring pliers together fairly hard and pull out the snap ring. Note: Make sure you have snap ring pliers because snap rings are very tool specific.
jack up front of mower so the wheel is off the ground. remove the cap covering the center hub. spread snap ring with snap ring pliers or screw driver to dislodge from groove. slide off snap ring and then pull off wheel
most of them are , one bolt and a snap ring holding the tire so you need some snap ring pliers
there i a snap ring on the inside and a ring on the outside and it will fall off in your hand if not a cutting torch is a pretty preswasive way to remove it also
First take off the horn pad , then you will see a snap ring on top of the nut remove it then you can use a socket to remove the nut , also there is a lead weight that will come off when you remove nut . You can get a steering wheel remover , but i just rocked the wheel back and forth while pulling and the wheel comes off , to get at the signal light switch you will have to remove a metal plate , you can do this by popping the snap ring off and that releases the plate Hope this helps
Use a snap ring pliers, available in various sizes -- try auto parts store.
if you didnt bend it during removeal then it is fine to re-use it.
Did you remove the big snap ring that's inside of the hub. It's hard to see.
you don't.They are part ot the half shaft REMOVE THE WHOLE SPINDLE FROM THE CAR. WITH DEEP WELL SOCKET OF CORRECT SIZE AND HYDRAULIC PRESS, PRESS OUT THE PART WITH THE WHEEL LUGS THEN TAKE BIGGER OF THEM {THE INSIDE} TURN IT OVER REMOVE THE SEAL, THEN THE SNAP RING AND PRESS IT OUT FROM THE INSIDE.
Remove the steering wheel, the snap ring and plate, the signal light switch, and you will find the bolt that holds the lock cylinder
Remove the six bolts, pull cap, remove snap ring. Snap ring could be covered by grease.
Remove shift release button off the top of the shifter, inside there is a small snap ring. Remove the snap ring and lift the shifter knob off.
remove the steering knuckle from the car and press, hub out of the knuckle. then remove snap ring and press out bearing you need a strong shop press