answersLogoWhite

0


Best Answer

I own a 1998 and a 2007 Rav 4, both with soft covers. The manual for the 2007 only shows the LTD and Sport covers- Hard Type- with the latch. To remove, start at the top and gently roll back the vinyl portion, and then work out from the center to the sides- the side portions have little or no elastic. Tilt out the cover, and with the rear door open, work the bottom portion out and off of the spare. To replace, reverse the process, by starting at the bottom with the rear door open. You must move the cover from side to side to allow the elastic portion on to work it's way on to the tire. As the cover begins to slip forward and over the tire, continue to position the cover. The cover can be adjusted for alignment by grabbing it at the sides and rotating it a bit, clockwise or counter clockwise. The are small dimples mid way down the cover on the outer edge where the painted part meets the vinyl, which are the level points so the cover is straight. Good luck, as writing about it is easier than doing it.

User Avatar

Ryan Lindgren

Lvl 10
2y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the spare tire cover on your 2007 rav4 you can not find the latch to release it that is described in the owner?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove fuse cover on Solara?

Which one? ;) The fuse box under the dash (left side next to the kick panel) simply pulls off. The one under the hood has a latch on the front. Pull out the tab to release the latch and lift the cover. Cheers


Can you make a release gas tank cover into a manual one?

Yes you can on some vehicles, you just need to disable or remove the latch that holds the cover closed. Some vehicles if you do this the cover will just stay open because of the spring that helps to open it once you pull the release lever.


How replace a broken rear hatch latch?

(1) Open the liftgate. (2) Remove the trim cover and latch mounting screws. (3) disconnect the actuating rod - detach electrical connectors (if any) - then remove latch from liftgate. Installation is the reverse of removal.


If the drivers door on a 1989 Accord will not open but everything appears to be connected how can you get the door open to replace the latch?

I have dealt with this problem before at our bodyshop. Basically, a spring inside the latch has broke, and now there is no way to release the latch, even by manually pulling on the release lever at the latch. Prepare to replace the latch, as it is not repairable. Be prepared to be working inside the car. To make it easier to work, unbolt the seat, and remove from the car. Remove the door panel, and also the door handle. You will have to chisel at the plastic part of the latch, and break it off bit by bit. Eventually you will be able to release the latch. good luck


Can you open the hood from the outside of a 2006 Chevy trailblazer if the hood release is broken?

If you remove the grill from the front of the truck you can then access the safety latch and hood release. My latch had rusted so I had to do this using a flat head screw driver and lifting the safety latch which allowed for the hood release to open.


Where is the release latch for a 1971 super beetle gas tank cover?

passenger side under the glove box


How do you exchange the battery pack on the notebook?

Release a latch and then remove the battery, then install charged battery into laptop.


How do you replace the radiator in a 2006 Buick Lucerne?

You have to remove the bumper cover, under bumper, and hood latch cradle. Then the ac condenser can be moved aside. Then remove fans and lines. Then remove radiator.


How do you change the air filter on a 1999 Toyota Avalon?

Find the air filter housing, the big black unit on the drivers side under the hood. It has clips that latch it into place. remove the clips and lift the cover, replace the filter and return the cover and re-latch it.


How do you replace the third brake light on a 2006 ford mustang?

# Remove the trunklid latch trim cover # Remove the electrical connector # Push in on the tabs and push light out of trunk


What is the best way to remove the cover to my remote to change the aa batteries?

The best way to remove the cover to your remote depends on the type of remote you have. Alot of remote controls have AA battery at the back of the remote. You simply unhook latch and slip down the cover to insert the battery.


How do you remove tail light cover on 2005 Ford Superduty?

open tailgate and there will be two screws. upper and lower. upper by the tailgate latch.