0
What else can I help you with?
Can you put a 1997 Nissan Maxima grill onto a 1996 Nissan Maxima?
Nope, they are different sizes. I have both a 96 and a 97 sitting in my driveway. The 97 grill looks a lot better, but they are not interchangeable.
How do you install an altrenator on 1996 Nissan Maxima?
To install the alternator on a 1996 Nissan Maxima you will have to remove the drive belt first and then the A/C compressor. Do not remove the refrigerant lines because the compressor will only have move down about a few inches for you to get enough room to remove the alternator. The alternator will need to be taken out from the bottom.
How do you repalce an alternator?
I need a step-by-step how to change, remove and replace an alternator in an 1996 Nissan maxima
Where is the location ecm on a 1996 Nissan maxima?
were is the location ecm on a 1996 Nissan maxima
Where are the spark plugs on a 1996 Nissan Maxima?
Where are the spark plugs on a 1996 Nissan maxima?"
Where is the wiper linkage bushing located on a 1996 dodge Dakota?
The linkage bushing is located under the Crowl grill. Remove wipers and grill.
How do I remove the rear speakers in a 1996 integra coupe?
You will need to remove the covers from your 1996 Integra rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.
Are the rear calipers the same for a 1991 Maxima and a 1996 Maxima?
no
When was Boc Maxima created?
Boc Maxima was created in 1996.
Can you put a 1997 Nissan Maxima stereo into a 1996 Maxima?
Yea why not
Where is the horn located on a Daewoo Nexie 1996?
The horn is located behind the front grill, on the center post. To remove the grill and reach the horn; small hands can reach the horn from underneath, or, to remove the grill, there are two screws on top of the grill, and two clips on sides, accessible from the top slits with a long screwdriver.
How do you remove the front inside door panels on a 1996 Toyota Rav4?
Just remove the four screws. Two in armrest, one on door latch handle cover, and in a cutaway between the side pocket and speaker grill. Gently pry off panel from door with flathead starting from the bottom up.
