answersLogoWhite

0

remove 13 mm nut connecting positive to starter motor, unclip smaller wire next to it, remove the three (3) bolts attaching starter motor to engine housing...that's how i just removed mine 5 minutes ago

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the starter in an 1989 VW Jetta?

The starter in the 1989 VW Jetta is located on the passenger?æside of the vehicle inside the engine compartment. It is below the battery box and low on the engine itself.?æ


How do you remove a starter from a 98 jetta wolfsberg edition can't find the rest of the bolts?

Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.


How do you change the starter on a 1989 Toyota Camry?

Remove wiring remove the 2 bolts holding the starter to the engine,remove the starter,you might want to remove the air filterhousing and inlet hose.


How do you replace the starter in an 1989 cavalier?

Disconnect the - battery cable Raise and support vehicle Disconnect the wiring at the top of starter Remove starter mounting bolts Remove starter


How do you replace starter on a full size 1989 Ford Bronco?

remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter


Where is the starter relay located on a 2002 Jetta GLS 1.8t?

Where is the starter relay located on a jetta 1997 truck 2.0?


How do you remove a starter from a 1989 Honda Accord LE?

Hey Candace==Remove the negative battery cable. Then remove the wires from the starter then the mounting bolts and work it out. GoodluckJoe


Any VW jetta questions?

where is located the starter at 1990 Volkswagen jetta


How do you remove a starter from a 1989 Corvette?

To remove the starter from a 1989 Corvette, first disconnect the negative battery cable to ensure safety. Then, access the starter by lifting the car and removing any obstructing components, such as the heat shield. Unbolt the starter from its mounting using the appropriate socket size, and carefully disconnect the electrical connections, noting their positions for reinstallation. Finally, remove the starter from the vehicle.


How do you replace starter motor on 1999 jetta?

disconnected the batteris - disconnet the wiring on starter motor,make not of the cables remove the two bolts securing the start to the car, installation is reverse Disconnect and REMOVE the battery. This allows you to get to the wires on the starter much easier. Then remove starter. Be sure to get the small bearing out of the housing and replace it. A new one should come with the starter, but if it does not, get one and put it in.


How do you replace the starter on a 1989 Toyota Corolla?

Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.


Where is the starter wire on 2001 Volkswagen jetta?

The starter kill wire is blue and red and is located in the ignition switch harness on the 2001 Volkswagen Jetta. The wire can be disconnected at the harness or at the starter itself.Ê