Disconnect the - battery cable
Raise and support vehicle
Disconnect the wiring at top of starter
Remove mounting bolts
Remove starter
lay under the car and sweat a lot.
Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
You should begin by removing the positive cable from your 1988 Chevy Corvette battery. Remove the cables from the front of the starter. Remove the three starter retaining bolts. Reverse the process to install the new starter.
Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
remove neg.cable.then positive cable cable from starter,remove male to female wire ,then remove 2 bolts holding starter to engine.
To remove the starter from a 1988 Lincoln Mark VII, first disconnect the negative battery terminal to ensure safety. Then, locate the starter, which is positioned near the transmission. Remove the electrical connections from the starter, followed by the mounting bolts securing it to the engine block. Once the bolts are removed, carefully pull the starter out of its position.
To remove the starter from a 1988 Acura Legend, first disconnect the negative battery cable to ensure safety. Then, locate the starter, which is typically mounted on the transmission bell housing. Remove the electrical connections, including the main power wire and the smaller signal wire. Finally, unscrew the starter mounting bolts and carefully pull the starter out of its position.
The starter is located under the engine, right alongside the crank case. As you look to the front of the car, it's on the left side of the crank case.
Remove - battery cableRaise and support vehicleDisconnect wire at top of starterRemove mounting boltsRemove starter
Because its a 1988 Buick LeSabre
Disconnect the battery. Unhook the starter wires. Remove the two bolts on the starter. Take the starter out, and bolt the new one in. Reverse the procedure to finish the installation.