remove starter bolts remove cable and wires
Remove the positive cable from your 1997 Oldsmobile battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
I got an '84 olds with the 2.8 V6 and I average around 20 MPG
Disconnect the - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter
(optional - safety) Disconnect battery negative connection. Remove plastic cover at front of starter. Unbolt two wires at back of starter. Remove two starter mounting bolts. Remove starter. Reverse above procedure substituting replacement starter for starter being replaced noting that the battery being connected is no longer optional.
you need to remove the black plastic air dam that is covering the bottom of the engine. The starter is then accessible at the front of the motor
It is located directly above the starter. Remove the starter and you will see it going into the side of the engine block.
It is located behind the starter. You'll need to remove the starter to replace it.
1997 olds achieva remove starter and wire plug got pulled out and we cant find where it goes? help?
i usually remove stuff with a hammer, but if you want it to work after wards go to a mechanic.
well the easiest way that i have found to remove a starter is to UNHOOK BATTERY CABLES THEN UNBOLT THE STARTER FROM THE MOTOR YOUR HONESTLY A DUMB A@@ for asking this
To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.
Disconnect - battery terminal Raise and support vehicle Disconnect wiring at starter Remove 2 mounting bolts Drop starter
First remove the negative battery cable. Then take the wires off of the starter solonoid. Then take the bolts out of the starter and remove it. Sometimes you have to take the exhaust loose to get it out. If necessary, get a manual from aparts store. It will show you how.
The solenoid is on the starter.
how do i change the starter on a 1997 olds 88 royale?
inside the starter.
Remove intake manifold from top of engine. It's underneath See previous question about location of manifold
how do you replace a starter on a 1998 cutlass
one hour or less remove the starter on the lower front of the motor and the sensor is right above the starter held in with one bolt
Disconnect the negative ground cable, then the positive cable. There is a center bolt holding the cables in place. Remove the battery hold down clamp which is located in front of the battery. You will probably need an rachet with an extention to get down to the hold down clamp which is between the battery and the front of the battery bracket. It may be necessary to remove the cross piece that runs across the… Read More
5 x 100
i am replacing the starter on olds 1995 aurora
Follow the red wire from the battery and it will go to the starter.. Be sure and disconnect the red (positive) wire from the battery before attempting to remove the starter..Remove the bolts holding starter to the motor and remove the wires to have it totally uninstalled. Take it to your parts store and they can test the starter to make sure it is faulty. The starter is located under the intake manifold. Remove:top cover,front… Read More
Could be: but - Get the part number for the 98 olds replacement from your online auto parts and the number for the year you have on hand and see if they are the same. Pull the 98 starter and compare it with the old starter you have.
no i dont think so
It may not have one on a '73. If it does it would be under the dash.
it is in the front on the bottom. unscrew the wires take out the two bolts and pull it away from the engine. be sure to take the battery ground off first.
Battery cable to starter?
get a floor jack and a block of wood and jack up the motor from the oil pan then get a socket and take out the two bolts move it around till it drops out and remove the two wires. same to put it back in
follow the positive battery cable down to the starter solinoid which is mounted to the starter motor, the starter motor should be on the same side as the battery is. good luck
On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.
It's down behind the starter.
If it's a similar engine, yes
If the 1996 Olds Aurora will not start and there is a clicking noise from under the front panel, check the starter. The clicking noise is probably from the starter solenoid.
Remove by gently pulling on the area surrounding the adjustable vents.These are tight and springloaded into the dash. Be careful. Takes time.Once removed, remove screws (if any).remove clear glass on speedometer etc.Replace ALL BULBS with long life type
The Olds Aurora has the starter sitting inside of the engine. You'll need to take off the intake manifold to get to it, and even then its a tight squeeze. Once you get the intake manifold off it will be highly visible.
The starter is under the intake manifold plenum. This is the large black plastic assembly under the engine cover. Ther starter sits in the VALLEY.- TechJK ----------------------------
I just changed the starter on my cutlass cierra 92, and I took it just one step at a time. I disconnected the battery, then I jacked up the car and put the front on jackstands. Then under the motor just behind the radiator, you will find your starter. There is a dust cover that is held by one nut. you must remove this. It has two bolts (i used 15mm socket) and if they… Read More
The starter is located under the intake manifold. It is in the VALLEY between the cylinder heads. Under the hood Under the hood
The starter will cost you around $170 + tax. Labor will be around $75, for a total of around $245.
Follow the pos battery cable and it is at the engine end.
Under the car on the drivers side front of the engine
Remove instrument cluster in a 2003 olds aurora
The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.
If it is a V6, it is located in front between engine and the cooling fans.
An engine that is compatible with the 1984 Cadillac 4.1 is the Olds 307. Another possibility is the Vortex 350.
unsnap rubber pad on top of bumper and remove and go from there .
This depends 100% on what engine it is.