It is located directly above the starter. Remove the starter and you will see it going into the side of the engine block.
behind the harmonic balancer
where are the camshaft position
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
It is located behind the starter. You'll need to remove the starter to replace it.
Possibly. That was the problem with my 2003 4.0.
If your 3.5 engine is the same as that in a 2001 Olds Aurora, go to www.autorepair.about.com and search on "2001 aurora 3.5 crank sensor". One of the hits will be a diagram of where the crank sensor is located (above the starter motor). Note that for this engine, a "relearn" mjust be done after replacing the sensor. There is a link to the procedure for removing/installing the sensor and for doing the "relearn". Hope this helps
You will fine it right on side of the starter on the front side of the motor
You have to drop the starter on the front bottom driver side of the engine... next to the transmission. The crank sensor is about in the middle of the block. One bolt holds it in.
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
There isn't one on that engine. Only a crankshaft sensor at the back of the engine.
i have a 2003 olds alero i need to know the location of the camshaft sensor
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...