0
Could my 2001 olds aurora 4.0 be stalling because of the code p0385 crankshaft position sensor?
Rreyesmwf
Possibly. That was the problem with my 2003 4.0.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where are the camshaft position sensor and crankshaft position sensors located in a 1996 olds aurora?
where are the camshaft position
Where are the 2 crankshaft position sensors located on a 2001 Oldsmobile Aurora 4.0?
where
Crankshaft censor in 02 olds aurora?
The crankshaft position sensor on this aurora is on the front lower portion of the engine. On the 3.5l v6, there is 1 , on the 4.0l v8 there are 2.-- TechJK ----------------
Why is your Oldsmobile aurora hard to start?
cured my hard to start aurora by changing crankshaft position sensor and having sensor re-learned by tech with proper tools
Why would the tachometer in a 2001 Oldsmobile Aurora ping and stay there at idle after starting the car?
I hear it is the crankshaft position sensor (CPS) on the car, we have an Aurora in the shop now with this problem.
2001 Oldsmobile aurora code P0385?
Trouble code P0385 means: Crankshaft Position (CKP) Sensor B Circuit
Where is the crankshaft position sensor located in the 2002 olds aurora 3.5l?
It is located behind the starter. You'll need to remove the starter to replace it.
On a 2000 Olds Intrigue where is the crankshaft position sensor located?
I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.
Where is the location of the crankshaft sensor on 2001 aurora?
Aurora 3.5 - the sensor is on the front of the engine, on the right side, up behind the starter. You can see it from the bottom looking up, but you have to remove the starter to get it out. The Aurora 3.5 has a single dual sensor. The Aurora 4.0 has two separate sensors.
What are symptoms of bad crankshaft position sensor in 2001 oldsmoble aurora?
Sometimes the car will stall, or you might have it where it is hard to start. My check engine light came on, and it is always best to change both sensors at same time, usually if one goes the other is going.
Location of crankshaft position sensor on 3.5 Oldsmobile?
If your 3.5 engine is the same as that in a 2001 Olds Aurora, go to www.autorepair.about.com and search on "2001 aurora 3.5 crank sensor". One of the hits will be a diagram of where the crank sensor is located (above the starter motor). Note that for this engine, a "relearn" mjust be done after replacing the sensor. There is a link to the procedure for removing/installing the sensor and for doing the "relearn". Hope this helps
Where is the crank position sensor located on a 1995 Oldsmobile aurora?
Behind oil filter
