Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
Where is the speed sensor located on a 1997 Oldsmobile Aurora
I need to locate the IAT sensor on my 2001 Aurora
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
The 1995 Oldsmobile Aurora 4.0 liter engine crank sensor is located on the back of the crank. You will need to remove the rear engine cover in order to view the crank sensor.
cured my hard to start aurora by changing crankshaft position sensor and having sensor re-learned by tech with proper tools
The Camshaft Position Sensor is located behind the Power Steering Pump.
Throttle position sensor
your o2 sensors are located before and after your catallytic convertors
On my 1998 Aurora with 4.0L v8, the air intake temperature sensor is located on the air filter housing on the driver's side of engine compartment.
where are the camshaft position
---------------------------------------------------------- The camshaft positioning sensor is hidden behind the starter motor on the 3.5 6-cyl. engine. I think it's the same for the 4.0. The starter motor must be removed to replace the sensor.
I hear it is the crankshaft position sensor (CPS) on the car, we have an Aurora in the shop now with this problem.
Trouble code P0385 means: Crankshaft Position (CKP) Sensor B Circuit
If your 3.5 engine is the same as that in a 2001 Olds Aurora, go to www.autorepair.about.com and search on "2001 aurora 3.5 crank sensor". One of the hits will be a diagram of where the crank sensor is located (above the starter motor). Note that for this engine, a "relearn" mjust be done after replacing the sensor. There is a link to the procedure for removing/installing the sensor and for doing the "relearn". Hope this helps
Its located on the back of right cylinder head ...fun too get too.....
It's located directly above the passenger side trans-axle shaft.
front right of cylinder head
The 1995 Oldsmobile Aurora cooling system temperature sensor can be found on the front of the engine. The sensor will be above the thermostat housing.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
show location of camshaft position sensor for 2002 Oldsmobile bravada.
It is located beneath the power steering pump in the engine block
It is located behind the starter. You'll need to remove the starter to replace it.
its located under the reserve tank...and if that is not working and you are for sure the you will have to replace the whole tank by dealer or maybe find on-line somewhere!
where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5