i usually remove stuff with a hammer, but if you want it to work after wards go to a mechanic.
remove starter boltsremove cable and wires
Remove the positive cable from your 1997 Oldsmobile battery. Remove the starter cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
you need to remove the black plastic air dam that is covering the bottom of the engine. The starter is then accessible at the front of the motor
It is located directly above the starter. Remove the starter and you will see it going into the side of the engine block.
It is located behind the starter. You'll need to remove the starter to replace it.
It is attached to the starter, which is under the car. Look for the rear of the starter sticking out on the driver's side of the car. Remove the housing cover (3 bolts), and then the 2 bolts hold in the starter to remove it and gain access to the solenoid. TD
1997 olds achieva remove starter and wire plug got pulled out and we cant find where it goes? help?
get a floor jack and a block of wood and jack up the motor from the oil pan then get a socket and take out the two bolts move it around till it drops out and remove the two wires. same to put it back in
well the easiest way that i have found to remove a starter is to UNHOOK BATTERY CABLES THEN UNBOLT THE STARTER FROM THE MOTOR YOUR HONESTLY A DUMB A@@ for asking this
To replace a starter in a 1985 Olds car, raise the front end of the car with a jack, Next, remove the two support bracket bolts at the transmission and pry the support bracket away slightly to obtain access to the starter bolts.
Disconnect - battery terminal Raise and support vehicle Disconnect wiring at starter Remove 2 mounting bolts Drop starter
First remove the negative battery cable. Then take the wires off of the starter solonoid. Then take the bolts out of the starter and remove it. Sometimes you have to take the exhaust loose to get it out. If necessary, get a manual from aparts store. It will show you how.