answersLogoWhite

0


Best Answer

disconnect negative battery cable. remove small dash panel under steering column. remove the 2 nuts on either side of column directly under dash. Disconnect harness connections. with hood of vehicle raised, under brake booster the column is secured with a nut and bolt. Inside of vehicle behind brake pedal and under the carpet the column has 4 bolts fastened to firewall. to keep steering wheel centered be careful not to rotate when column is removed.

User Avatar

Wiki User

โˆ™ 2007-04-12 18:21:27
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the steering column on a 1991 Chevrolet Suburban?
Write your answer...
Submit
Related questions

How do you remove the steering wheel on a 1994 suburban?

How do you remove the steering wheel on a 1994 suburban?


Where is the signal flasher for the 1992 Chevrolet lumina car?

Just to the right of the steering column, close to the fire wall. Remove both plastic panels beneath the steering column to be able to see it.


How do you remove the steering column in a Chevelle?

Unplug the wiring harness from the steering column. Remove the cover plate under the column. Remove shift linkage. Remove two bolts under the dash that hold the column up. Remove the two nuts that connect the column to the steering knuckle. Slide it out.


How do you remove the brake pedal on 98 suburban?

To remove the brake pedal on a 1998 Suburban, unscrew the bolt that holds it to the steering wheel column. There are several wires that also have to be disconnected from here that control brake lights.


Do you have to remove the steering wheel to remove the column on a 2003 GMC sierra?

No. You can remove the entire column with the steering wheel still attached.


How do you remove the steering column in a 1986 Chevy Celebrity?

To remove the steering column in a 1986 Chevy Celebrity: 1. Remove the trim panel under the steering column. 2. Remove the noise panel. 3. If the car has column shift remove the gear indicator from the shift bowl. 4. Unplug electrical connectors. 5. Remove the four bolts that hold the steering column up. 6. At this point the steering column should pull out.


How do you remove steering wheel on frontier?

Disconnect battery. Remove air bag. Remove bolt holding steering wheel to column. Use a steering wheel puller to remove wheel from column.


How do you take out a steering column on a 1977 Chevy pickup?

Unplug the wiring harness from the steering column. Remove the cover plate under the column. Remove shift linkage. Remove two bolts under the dash that hold the column up. Remove the two nuts that connect the column to the steering knuckle. Slide it out.


How to remove power steering pump 1994 suburban?

Begin by removing the belt from your 1994 Chevy Suburban power steering pump. Remove the power steering pump hose. Remove the power steering pump retaining bolts. The power steering pump will come off.


How do you remove and replace a steering column in a 95 Cadillac Sedan Deville?

How to remove and replace a steering column on a 95 Cadillac Sedan Deville?


Remove steering column 1995 ford van?

Disconnect battery. Wait 10 minutes, then remove airbag module (if equipped) and horn pad. Remove steering wheel. Pull off plastic trim panel below steering column. Turn ignition key to run (not start) and press lock tang to remove lock cylinder. Remove steering column lower shroud. Remove steering column upper shroud. Remove multi-function (turn signal/wiper/hazard) switch. Remove metal 'knee brace' bracket below steering column. Disconnect all affected wiring including wiring to ignition switch. Remove pinch bolt at bottom of steering column. Remove 2 nuts and t bolts mounting steering column. Note that it will now drop down and may pinch fingers or toes. Remove column from vehicle.


How do you remove the steering lock on a 1994 Ford Probe?

# Disable airbag system. # Remove steering column covers and lower instrument panel cover # Lower steering column # Disconnect the shift interlock cable from ignition lock housing # The lock assembly is clamped to the steering column by two shear-head bolts. Drill heads off each bolt and remove the bracket. # Remove the steering lock assembly from the steering column


Where is the Emergency flasher location 1994 suburban?

The switch is inÊthe steering column,Êyou will have to remove the steering wheel to access it. The flasher fuse is round-shaped about the size of a quarter in the fuse panel under the dash.Ê


1994 mercury villager shift lock solenoid?

The shift lock solenoid is located on top of the steering column. You will need to remove the steering column covers, lower dash trim, and the heater duct. Remove the steering column bolts and lower the steering column to access the shift lock solenoid.


When replacing the heater core on a 1999 Blazer is it necessary to remove the entire steering column surrounding components?

drop the steering column, remove entire dashboard.


How do you remove front rotors from 1999 Chevrolet suburban?

Remove the tire and wheel from your 1999 Chevrolet Suburban. Remove the brake pads and break assembly. Tap on the rotor with a hammer or mallet. When the rotor is loose it will slide off.


Removal of steering wheel 1994 Chevy S10 4x4 blazer?

I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!


How do you remove the steering wheel from a 1973 Chevelle steering column?

you need a steering wheel puller to get it off.


How do you remove the ignition switch tumbler on a 1986 dodge lancer 2.5?

Remove the screws on the side of the steering column. Remove the screws underneath the steering column and pull the bottom half of the column down. Slide a pin punch into the hole at the ignition tumbler assembly's bottom. Force the tumbler upwards and pull it out of the steering column.


How do you remove the steering column bearings on a 1994 ford F350?

remove column dust covers, along with ignition switch. then remove retaining


How do you change the power steering pump on a 1997 Chevrolet Express Van?

You will need to remove the power steering pump belt in your 1997 Chevrolet Express. Remove the power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.


How do you remove the cover to a 2001 Chevy Blazer Steering wheel column?

How to Remove the Steering wheel From a Chevy Blazer 2001


How do you go about changing the entire steering column in an automatic 1989 Firebird?

steering column removalto replace steering column: take lower cover off, then there is a bracket on the bottom of the column with four brass bolts in it, remove those. on that same bracket there are two metric nuts on either side of the column, remove those. now the column will drop. next remove the ignition switch and dimmer switch. now that u dropped the steering column you will have access to them. go ahead and remove three bolts from where the steering column meets the firewall(you will need to pull the carpet back a little). next pop the hood and locate the steering gear on the drivers sidetowards the front take ou the bolt holding in the shaft to the gearbox. and then the steering column should slip right out.


How do you tighten tilt steering column on 89 Cadillac sedan deville?

How long does it take to remove a steering column on a 1989 Cadillac Deville


How do you remove head restraints for 1995 Chevrolet suburban front seats?

you can't