Steering and Suspension
Ford Probe
1995-2005 Chevy Cavaliers
DIY Projects

How do you remove the steering lock on a 1994 Ford Probe?

151617

Top Answer
User Avatar
Wiki User
2007-09-23 02:09:10
2007-09-23 02:09:10

# Disable airbag system.

# Remove steering column covers and lower instrument panel cover

# Lower steering column

# Disconnect the shift interlock cable from ignition lock housing

# The lock assembly is clamped to the steering column by two

shear-head bolts. Drill heads off each bolt and remove the bracket.

# Remove the steering lock assembly from the steering column

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.

User Avatar

remove column dust covers, along with ignition switch. then remove retaining

User Avatar

1. Disconnect the negative battery cable. 2. Remove steering column covers 3. Disconnect the electrical connector from the ignition switch 4. Remove the screw retaining the switch to the steering column 5. The following installation is reverse of removal

User Avatar

How do you remove the steering wheel on a 2004 ford freestar

User Avatar

no, the 89-92 engine/transmissions are different from the 93-97 ford probe.

User Avatar

You can remove the steering will, on your Ford Ranger pickup truck, by removing the steering wheel pin. Remove the wiring harness and the steering wheel will come off.

User Avatar

with a power steering puller, which can be rented at Advance auto parts or Auto Zone

User Avatar

does anything need to be taken off to remove a started on 89 ford probe

User Avatar

stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.

User Avatar

Remove the steering wheel ford f-250

User Avatar

what is the spark plug gap for an 1989 ford probe lx? Thank you.

User Avatar

I want to know what is the proper spark plug gap for my car. It's a Ford Probe 1994, 4 cylinders and 2.0L

User Avatar

For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.

User Avatar

your firing order for your probe is 1-4-3-2

User Avatar

I was under the impression the switch was on the steering column about 18 inches from the floor. The lock assy is under the steering wheel.

User Avatar

Subaru wheels do not fit on a 1994 Ford Probe because of fundamental design differences. Both have a similar appearance, however the bolt pattern and sizes are different.

User Avatar

Maybe this will help : http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-ford-probe-gt-v6/

User Avatar

hi, i could'nt find the inertia switch on my ford probe 1994 for ages. Eventually I found it just above the wheel arch on passenger side in boot but you have to remove the plastic covering. Not easy to locate. Hope this helps.

User Avatar

between the engine and the drive wheels

User Avatar

you buy one or take it to the shop

User Avatar

It is Inside of the fuel tank.

User Avatar

Yes.I have a 1994 Ford tempo GL with a 2.3l engine, automatic transmission, air conditioning, power locks and tilt steering.

User Avatar

Take the hose off of the steering rack and plug it so the fluid won't run out and then take the other end of the hose off the steering pump.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.