It is on the back side of the engine where the engine meets the bell housing. It is down at the bottom and the battery and tray have to be taken off to remove the starter from the engine and get it out at the top.
the pictures was found in 1994 where the space probe was found by: bob marly
Yes, the entire starter needs a rebuild by then. $80 at your local rebuild shop IF you remove it yourself and bring it to them. Usually has a 1 year standard warranty.
Once started the fluorescent tube no longer needs the starter. In fact starters are designed to electrically "remove" themselves from the circuit when the fluorescent tube is conducting.
Changing a starter in a 1985 Pontiac Sunbird is not very difficult. The car will first need to be jacked up. After the car is jacked up, locate the starter. The wires will need to be taken off the starter and labeled so they can be reattached to the new starter. The starter is then taken down by using a ratchet to take of the bolts. After the starter is taken off, the new one can be put on.
Changing the starter on a 1996 DeVille sedan can be a little complicated for beginners. The intake manifold will need to be taken off the car before the starter can be removed. After the manifold is removed, the starter can be taken off. The wires will need to be taken off the existing starter and labeled or taped for the new starter. The start is held in place by two bolts and after the bolts are removed the old starter can be removed.
Replacing the starter on a 1991 Chevrolet Cavalier can be difficult for someone who has never worked on cars. The car first needs to be jacked up so that the starter can be reached. Then the wires will need to be taken off the starter and labeled so that they can be placed back on the new starter. The start will then then be taken off by removing the bolts. After the bolts are removed, the starter can be taken off and replaced.
you sure can! :) ive taken that adventure
Many have done so for several years
Once started the fluorescent tube no longer needs the starter. In fact starters are designed to electrically "remove" themselves from the circuit when the fluorescent tube is conducting.
Not certain of model 323F; my standard 323 has the 1.6 L OHC engine and you can change the starter motor as follows: The starter motor is located on the back side of the engine (closest to the firewall) underneath the fuel injection/intake manifold. To replace it, first disconnect the battery, then remove the main power cable (heavy wire) and the start wire (light wire). Next remove the two bolts for the intake manifold support bracket and remove bracket. Remove one bolt on starter rear support bracket and 3 bellhousing flange bolts (two accessible from starter side, on accessible from bellhousing side). the starter is now free and can be taken out form the passenger's side (LHD). Good luck Malcolm
No.He gets it as a starter Pokemon because the proper starter Pokemon was taken.