Be notified when an answer is posted
Oldsmobile didn't make a Cutlass Supreme in 1998
On my 1996 Oldsmobile cutlass supreme it was very easy to remove the stereo. The entire plastic molding piece that surrounds the stereo as well as covers the speedometer is attached by some push clips and can be simply pulled off, no screws. Once the plastic surrounding is removed there will be 2 screws holding the stereo in place. Remove the 2 screws and pull the stereo out. Unplug the wire harness and antenna.
You can unlock your Oldsmobile Cutlass antitheft stereo by removing the stereo fuse. Keep the fuse out for 30 seconds and replace it to its original position.
show wire names for car stereo
is there 2 holes on each side of the radio : : like that
In the center console, ( if you have a computer readout system be carefull) gently pull the trim cover off, it just snaps in place, once removed, there will be 2 bolts at the bottom of the stereo, remove tham and the stereo slides out. If you plan to put in an after market radio, be sure it is the same size as the original, or you will have to purchase a mounting kit for it, also you will need a wiring harness to attach to the new aftermarket stereo so it will plug into the original stereo wiring for the car.
To remove a stock stereo, you will first need to remove the bezel from the stereo. Then, pull the stereo out of the dashboard and remove the wiring harness.
http://www.modifiedlife.com/2001-oldsmobile-aurora-car-stereo-wiring-schematic/
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out. Remove the wiring harness and the antenna cable.
Remove the retaining cover from your stereo. Remove the stereo retaining bolts. Slide the stereo out and remove the wiring harness. Reverse the process to install your new stereo.
Remove the decorative stereo cover. Remove the stereo retaining screws. Pull the stereo out and remove the wiring harness and the antenna cable.
Remove the cover from your 2001 Chevy Silverado stereo. Remove the stereo retaining bolts. Remove the wiring harness and the antenna cable from the back of the stereo.