0
My 1993 Hiace has a Torsion Bar Suspension on the front. The tension retainer is halfway down the vehicle. Jack the vehicle up - remove the wheel, then undo the locking nut on the end of the torsion bar, ( mark with a dot of paint so that you tighten the bar to the correct vehicle height on reassembly) Once you have released the tension its a doddle to remove!!
What else can I help you with?
Will a 1992 Toyota hiace engine fit a 1998 Toyota hiace body?
yes it can
Where or the timing marks on a1998 disel Toyota hiace van?
how to fine timing marks on a 1998 hiace disel van 2l
How do you remove 1998 Toyota hiace corner light?
To remove the corner light on a 1998 Toyota Hiace, first, ensure the vehicle is turned off and the keys are removed. Gently pry off the plastic cover or trim surrounding the corner light, if applicable. Then, unscrew or unclip the corner light assembly from its mounting. Finally, disconnect the electrical connector and carefully pull the light out to complete the removal.
How do i get to wiper motor on 1998 Toyota Hiace?
To access the wiper motor on a 1998 Toyota Hiace, first, remove the plastic cover at the base of the windshield by unscrewing any screws or clips holding it in place. Next, disconnect the wiper arms by loosening the nuts and lifting them off the splines. Once the arms are removed, you can access the wiper motor, which is typically mounted under the cover. Unplug the electrical connector and unscrew the motor from its mounting to replace or service it.
Where is the fuse box located in a Toyota Hiace 1998?
next to the clutch pedal, there is a smaller fuse box for the normal fuses
How do you remove drivers side windscreen washer jet from 1998 Toyota Hi Ace?
been looking for this myself, the super custom has a steel clip like a door barrel retainer holding it in... you need to remove the dash to do this, there is no other way.... i believe the hiace is the same....
Where is the fuse for the clock in Toyota's hiace 1998?
In a 1998 Toyota Hiace, the fuse for the clock is typically located in the fuse box under the dashboard on the driver's side. Check the fuse diagram on the cover of the fuse box to identify the specific fuse associated with the clock, which is often labeled as "clock" or "accessory." If the clock is not functioning, inspect this fuse for any signs of damage or a blown filament and replace it if necessary.
How do you remove the back seat of a 1998 Toyota Corolla?
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
How do you you remove the rotor of 1998 Toyota Camry?
You need to remove the wheel, the caliper and the caliper mount. After you do that you can remove the caliper.
How do you remove the driver's seat on a 1998 Toyota 4Runner?
Remove the nuts! They are on the lower metal frame the seat
How do you remove the door panel of 1998 Toyota Tacoma?
Call an Auto body guy
How do you remove the starter from a 1998 Toyota 4runner 4 cylinder?
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
