should be two screws or bolts from just inside the tail gate area
Remove the fasteners and electrical connection from behind the assembly and slide the assembly out the front.
remove the screws holding the ring around the light then remove the light.
how do you remove the headlight assembly on a 2001 ford f-250
What model, ZX3? If that's the case then you need to remove the plastic nuts located behind the trim. With those removed then it's just a good yank on the taillight assembly.
open the end gate remove the hold down screws and carefullt remove the taillight assembly
Open the tailgate and remove the retaining bolts from the side of the lamp housing (tail light assembly). Take the assembly out of the fender. Rotate the bulb socket to align the lugs and take the socket out of the housing. To remove the bulb from the socket, carefully pry the retaining clip and pull the bulb out. Installation is the reverse. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.
There should be a SWITCH at the dome light! If not, remove the fuse from the fuse box above where your gas pedal is. OR: Simply remove the BULB from the dome light. duncanw.
The 1993 Ford Probe rear brake light lens cannot be removed. The tail light are a complete seal light. The light bulb's can be removed from the rear of the light assembly.
Open tailgate. Remove the light assembly screws. Rotate the bulb socket to align the lugs and take the socket out of the housing. Carefully pry out the ratainig clip and pull the bulb out of the socket. Installation is the reverse. - Haynes Manual #36071, 1993 - 2005 Ford Ranger Pickups, all models.
you have to pop the hood, DON'T take off the plastic! remove the light from the back
There are two screws on the outside of the tail light assembly. Remove these two screws (keep them) and the assembly should be able to be removed from the truck. Carefully twist the socket out of the tail light assembly. Pull the old light bulb out of the socket and replace with new. Insert the tail light assembly into position in the truck bed and replace the two screws.
Open the rear hatch, then remove the 4 screws holding the lens assembly to the vehicle. Remove the lens assembly by twisting it counter clockwise then pulling it out. Remove the bulb sockets by pressing in and turning counter clockwise then pulling it out. Do the reverse to put it back together.