1) Open the Tailgate. 2) Remove the two screws/bolts (one near the top of the lens assembly, one below; the only two (2) screws in the assmebly). 3) At this point you'll see that the assembly is loose. 4) Pull the assembly straight back (toward the bumper). After the two (2) screws are removed, the only thing holding in the assembly is a slightly, pressed fit of two alignment pins.
You must remove the entire tailight panel - remove trunk liner and the recessed nuts.
Lift the hatchback and remove the 2 screws holding in the taillight assembly. You can then access the light bulbs from the rear.
Open the tailgate and look at the sides. You should see some screws in there. Unscrew those, and the tail light lens should pull right out.
You will need to open the liftgate and remove the screws that hold in the tail light housing. Once removed, you can twist the bulb socket slightly to remove it from the housing and replace the bulb.
To replace the tailight out of a 1998 Cadillac Deville just remove the fuse and place a new one in the light\'s bulb.
Pull the carpet away from the back of the tailight assembly within your trunk. There you will find a series of plastic nuts that hold it in place; simply remove them and the light assembly will drop out. I hope this helps you. Mark
Youu need to open trunk lid remove the two screws holding tailight pull out tailight replace bulb very simple
Remove the trim panel from the inside of the trunk to gain access to the lamps.
Raise the hood. Remove the whole headlight unit. Nuts are reachable from inside. Not too difficult pc
The 2004 Nissan Quest has a V6 engine.
The 2004 Nissan Quest has 24 valves.
BASICALLY YOU NEED TO REMOVE THE BUMPER ENOUGH TO LOOSEN THE SCREWS FROM THE BACK OF THE TAILIGHT ASSEMBLY TO SLIDE IT OUT THE BACK.