Thermostat housing is a difficult piece to remove in 93 corolla as it is situated at a complicated place but with right tools and equipments it should be piece of cake.
You wil need wrench set with 12mm and 10mm sockets and also a screw driver and degreaser to remove hoses.
1) you want to remove all the hoses and wires that are attched to it.
2) degrease the part if necessary.
3) if you just want to change the thermostat, locate hose that is connected from radiator to housing, undo 2 nuts of 10mm head and you should have thermostat out.
4) to remove the whole housing, there are only 3 more bolts to remove, all 3 bolts are of 12mm head.
and you have the whole housing out.
hope this helped.
The thermostat is located by the side of the cylinder block near the coolant inlet. Remove the coolant inlet housing after disconnecting cables and loosening the holding bolts. You will be able to remove the thermostat to replace it.,
Follow the upper radiator hose from the radiator to the engine. The thermostat will be located behind the thermostat housing at engine end of upper radiator hose. Drain some coolant into a clean container. Remove upper radiator hose from thermostat housing. Remove the 3 bolts that hold the thermostat housing to engine. Remove thermostat housing. Remove thermostat. Be sure to install the new thermostat facing in the same direction as the old one was.
Follow the upper radiator hose from the radiator to the engine. The thermostat will be located behind the thermostat housing at engine end of upper radiator hose. Drain some coolant into a clean container. Remove upper radiator hose from thermostat housing. Remove the 3 bolts that hold the thermostat housing to engine. Remove thermostat housing. Remove thermostat. Be sure to install the new thermostat facing in the same direction as the old one was.
How i remove eveporator unit from toyota corolla 2002
Thermostat is located on side of cylinder block, behind coolant inlet housing for lower radiator hose and the generator. drain cooling system. rotate accessory drive belt tensioner clockwise to release tension from accessory drive belt. remove accessory drive belt. remove mounting bolts and generator. disconnect electrical connector from engine coolant temperature switch for removal of coolant inlet housing. remove nuts, coolant inlet housing, thermostat and gasket.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
how do you remove a center console on a 2001 toyota corolla
Remove the thermostat housing. where is, and how do i remove the housing
Remove the hose from the thermostat housing then remove the housing and then the thermostat.
follow the lower radiator hose to where it clamps to the engine. that is the thermostat housing. remove the 3 12mm nuts on the housing and the stat is right there.
where the lower radiator hose attaches to the engine block you will find a housing with several bolts to remove them and you will find your thermostat.
how do u remove cv axle driverside 1991 toyota corolla