Buick Century

How do you remove the thermostat located on a 1995 buick century?

353637

Top Answer
User Avatar
Wiki User
2009-07-29 18:07:41
2009-07-29 18:07:41

Follow the top of the water pump hose. at the end of the hose you will see a houseing with two bolts that hold the therostat. clean both surfaces of dirt,old gasget. A flat putty knife is good for this, be careful not to cut into the metal, replace therostat and seal it helps to use a high temp sealent on both sides of the metal before installing the gasget. p.s. be sure to put the therostat in the way you took it out. Run engine and replace anti-freeze.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Drain the radiator. Remove the top radiator hose on the 2003 Buick Century. Unbolt the hose inlet. Remove the inlet housing and take out the thermostat. Replace the thermostat, install the housing and top hose, and refill with antifreeze.

User Avatar

where is the thermostat located in a 2003 buick lasaber

User Avatar

The thermostat is located in the top radiator hose connector. The top hose and the housing need to be removed for access.

User Avatar

Where is the thermostat located on a 1987 Buick LeSabre?

User Avatar

where is the thermostat located on 95 buick regal

User Avatar

The hose that goes in the top of the engine, the thermostat is in the hose.Unscrew the hose take the thermostat out and replace,Very easy

User Avatar

follow the radaitor hose from the top right side it goes directly to the thermostat housing remove the bolt then there is your thermostat

User Avatar

The thermostat on a 1991 Buick Skylark is located near the engine. To find the thermostat, follow the top radiator hose directly to the thermostat.

User Avatar

Look in the removable housing at the engine end of the upper radiator hose

User Avatar

Look in the housing located at the engine end of the upper radiator hose

User Avatar

how do I remove the sunvisors off a 1999 Buick Century

User Avatar

Checkhttp://autorepair.about.com/library/faqs/bl113g.htm

User Avatar

Drain the radiator. Remove the top radiator hose and water inlet. Remove the thermostat from under the inlet. Install the new thermostat, reinstall the inlet and hose, and fill the system with new freon.

User Avatar

Follow the top radiator hose back to the engine. The thermostat is behind the housing that connects the top hose to the engine block.

User Avatar

drain coolant then remove thermostat housing remove thermostat replace with new one spring to block

User Avatar

At the end of the upper radiator hose is where the thermostat is located as with all cars. It may be difficult to remove due to all this other crap that is in the way.

User Avatar

The Thermostat is located in the neck where the upper radiator hose connects to the engine. you have to take off the upper intake plenum to access this. Alot of crap just to change the thermostat. excellent design GM. Jamie

User Avatar

locate the top hose on the radiator drive side follow it back to thermostat housing it's were the clamp is at on the end of the hose.

User Avatar

follow the top radiator hose till you get to the water neck, take off the water nech and it should be there.

User Avatar

The fuse box is located in the glove box on 1991 Buick Century

User Avatar

If there is a bleeder valve, it would be located at the top of thermostat housing

User Avatar

I believe it should be in the intake just above the thermostat housing.

User Avatar

there are 2 large black hoses that come off of your radiator. the one located higher on the radiator (upper radiator hose) goes from your radiator to the thermostat housing. the thermostat housing is a metal tube that is bolted to the engine. the thermostat is located inside of the housing and can be accessed by removing the bolts


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.