You should have a small ratchet with a torx head driver on it in Your console near the rear. There are 4 bolts that hold the top on. 2 of them go horizontally into the rear of the top and into the rear header. The front 2 are in the 2 holes that are drilled verticle behind the sun visors. The torx driver is long enough 2 go through these holes and engage the bolts. Unscrew all 4 lift a bit on the front of the top and after it lifts You pull forward on the top and it should come out. If it wont You probably have a bolt left engages. Be careful with lifting the top out as it is akward and a bit heavy. I recommend 2 People. One on each side of the car till You get used to it. Good luck. Skip Underwood
Coupe or convertible? Yet another un-specific question.
The 1996 corvette does not have a T Top.
Remove the bottom hose from your 1995 Chevy Corvette radiator. Allow the coolant to drain out. Put a hose into the top of the radiator. Run water through the radiator until it runs clear.
there are four bolts then the top will pick straight off
The 1995 Chevrolet Corvette on relay switch can be found in the fuse box. The horn relay switch will be in the third column, second from the top.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
The Chevrolet Corvette Coupe and Convertible have a Top Speed of About 190. The Next Level up (The Z06) has a top speed of 198 and finally the all mighty ZR1 has an amazing top speed of 205. I'm sorry, but the ZR1 has a top speed of 225. and that's with a acceleration limiter!!
Remove the 4 bolts at each corner of the top with the supplied tool that should be in your console. If the tool is missing, seek a replacement.
theres a special tool to remove 4 bolts. and you take it off and you be cruisin
The coil is located in the top part of the distbutor cap
There are 4 bolts, 2 in front & 2 in back. You need the tool to remove the bolts.
Yes they can. There are 4 screws with a specialized head meant for the ratchet that came with the car in the console storage. Then the brackets in the back will hold the panel backwards while you drive. similar to the T-tops of the 70s.