There is a 6 or 7 sided Star shaped thing in the middle of the top of the cover. You need to turn it counter clockwise. If you cant do it by hand use a pair of plyers -RC-
Relay is in underhood fuse block marked A trans
There is an underhood fuse block, left fuse block in the left kickpanel (by the drivers feet) and also in the right kick panel
It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket
BODY CONTROL MODULE REMOVAL Disconnect battery negative cable. Remove lower steering column cover and knee blocker reinforcement. Disconnect two wire connectors from bottom of Body Control Module (BCM) Body Control Module . Remove bolts holding junction block to dash panel mounting bracket. Remove junction block from mounting bracket. Remove screws holding BCM to junction block. Slide BCM downward to disengage guide studs on junction block from channels on BCM mounting bracket. Remove BCM from junction block. INSTALLATION Reverse the preceding operation The BCM is located near the parking brake behind the drivers side kick plates (mentioned above) It has 5 plugs in it, one 6 pin plug and four 34 pin plugs.
First of all disconnect the battery before starting with the other steps. After this remove the lower steering column and the knee blocker reinforcement to be able to access the cables connecting the Body Control Module. Remove the two wire connectors which are located at the bottom of the module then unscrew the bolts that are holding the junction block to the mounting bracket of the dash panel. After this was done, remove the junction block itself and remove the screws that are holding the module to the junction block. Next slide the Body Control Module downwards out of the junction block. This will disengage the guide studs on the block. To install a new BCM module, do the above steps in the reverse order.
Front seating area, center, under dash, front of console, mounted in junction block.
FRONT SEATING AREA, CENTER, UNDER DASH, FRONT OF CONSOLE, MOUNTED IN JUNCTION BLOCK.
Remove the fuel tank and run a new line all the way to the junction block below the master cylinder.Remove the fuel tank and run a new line all the way to the junction block below the master cylinder.
Remove underhood fuse block (there is a bolt between the body panel and the fuse block housing), set it aside Remove body strut. Unhook negative cable, then positive cable. Loosen battery tie down bolt. Remove battery. Installation is reverse of removal.
1 fuse block underhood 1 in instrument panel beside left leg and 1 in right side panel on pass. side total of 3 fuse blocks
Front seating area, center, under dash, front of console, mounted in junction block.
underhood next to block twords the back of the vehicle