0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you get glove box out of 1996 dodge Dakota?
I believe on the '96's you open the glove box and remove the screws on the top edge
Where is the flasher on a 1996 dodge ram 2500 van?
the flashers in the 1995 - 2500 ram van are located behind the glove box - have to remove inside of glove box to see them.
How do you replace a heater blower in a 1996 mercury villager?
Open the glove compartment and remove it. Disconnect the electrical connector and the three mounting screws. Remove motor.
When was Odyssey Re created?
Odyssey Re was created in 1996.
When was Odyssey Network created?
Odyssey Network was created in 1996.
Where is the front heater blower motor on a 1996 Mercury Villager?
Remove the glove box. The front blower motor and the resistor can be accessed from there.
When was Odyssey Television Network created?
Odyssey Television Network was created in 1996.
What actors and actresses appeared in Odyssey of Life - 1996?
The cast of Odyssey of Life - 1996 includes: David Ogden Stiers as Narrator
Remove the headrest from a 1996 beretta?
you must remove fabric from the upper seat there is a lock clip at the bottom of the post.. for more info... http://www.topspeedautogroup.com
Where is the ecu located on a 1996 Toyota 4 runner?
where is the ecu located on 1996 Toyota 4 runner
Do you have to remove the Upper Intake Manifold to replace the fuel pressure regulator on a 1996 Chevy Corsica V6 3.1L?
Correction: It is a 1995 Chevy Corsica. Not a 1996.
Where is the ecm on a 1996 olds ciera?
It is located directly on the firewall behind the glove box. It is easier to remove with less chance of damaging the ecm holder if you remove the screws on the front of the glove box, the screw holding the glove box retaining cable, and the bottom screws holding up the bottom cover just below the glove box. This will be easy since all of the screws are 7mm screws. The screws that hold the pins onto the ecm are also 7mm. You will then remove the ecm from the bottom but by taking the glove box out you can actually see what you are doing.
