answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +5 pts
Q: How do you remove the valve stem seal springs on a 1995 Chrysler Cirrus on the intake side where the spark plug tubes get in the way?
Write your answer...
Submit

Related Questions

How do you get to the back spark plugs on a 2000 chrysler cirrus?

You have to remove the upper intake manifold.


How do you replace spark plugs 2000 Chrysler cirrus 2.5L?

You have to remove the upper intake manifold.


How do you change the spark plugs in a 1999 Chrysler Cirrus 2.5L V6?

You have to remove the upper intake plenum.


How do you replace the rear spark plugs on a 2000 Chrysler Cirrus LXi with a 2.5L V6?

You have to remove the upper intake.


How do you remove anti theft system on 1995 Chrysler Cirrus?

How do i remove the anti theft system on my 1995 Chrysler Cirrus?


Removal of three sparks located behind the upper intake manifold on a 1995 Chrysler cirrus?

you must remove upper intake manifold to access these plugs


How do you remove the transmission from a 2000 Chrysler Cirrus with 6 cylinder engine?

was wondering if someone can tell me how in detail to remove the tranny from my 1997 chrysler cirrus i need to replace the torque converter seal


How do you replace the radio in a 98 Chrysler cirrus?

Remove the instrument bezel.


How do you acess the fuel pump to a 1996 Chrysler cirrus?

You have to remove the fuel tank.


How do you get to the battery in a 2000 Chrysler Cirrus?

Remove left front wheel, remove inner fender well, remove battery.


How do you replace rear Spark plugs in cirrus Chrysler 96?

You have yo remove the intake manifold(plenum),Go to your local auto parts store and get a haines manual.It will describe everything in detail.


How do you change the battery in a 2000 Chrysler cirrus?

You remove the left front tire, the left fender liner, and then can remove the battery.


How do you reset computer in 1996 Chrysler cirrus?

Remove battery ground for at least two minutes.


Where is the distributor on a 1997 Chrysler cirrus?

The distributor is on the right side of the motor and it is bolted with two bolts front and back. This part is to be removed very slowly a little at a time on each side where it is bolted. you must remove the intake to remove the dist. completely.


Where is the transmission drain plug for a 1995 Chrysler Cirrus lx?

There isn't one. You have to remove the pan to drain


How do you change a water pump on a Chrysler Cirrus?

It is fairly difficult to change a water pump on a Chrysler Cirrus. First, you remove the crankshaft pulley, remove one engine mount, take off the timing belt, and finally gain access to the pump. You can then feel free to switch them out.


Do you have to remove the intake manifold to do a tuneup on a Chrysler 300?

Yes, if the intake blocks access to the spark plugs.


Where to find the three visible spark plugs on a 98 Cirrus?

On v6 remove upper intake manifold


How do you replace the dome light light bulb in a 1999 Chrysler Cirrus LX?

If it is like my 2000 Cirrus, I use the key to pop the cover off, then just remove and replace.


How does a cam shaft come out of a 2000 Chrysler cirrus?

Over head cam, remove the valve cover and timing belt


Location of the radiator drain plug on a 97 chrysler cirrus?

Should be at the bottom or rear of radiator or remove the lower radiator hose


Remove and replace alternator on Chrysler cirrus?

disconnect the battery. Remove the alternator belt then disconnect the wires. Unbolt the alternator and remove. Bolt the new alternator in then connect the wires, belt, and battery.


2001 Chrysler Concorde how to take off intake?

Remove the air intake hose from the Concorde. Take off the throttle cables and any fuel lines or vacuum hoses in the way. remove the bolts for the intake, then lift it straight up to remove it.


How do you remove ignition 97 Chrysler cirrus lost key?

dont remove ignition take your vin # to dealer and they can cut a key for less than 10 bucks if it has no chip in it.


How do you Change the Oil pan gasket on a 1999 Chrysler cirrus?

To change the oil pan gasket on a 1999 Chrysler Cirrus, disconnect the negative cable from the remote battery jumper. Then remove the oil drain plug to drain the oil pan. Next, remove the drive belt and exhaust cross-pipe. Remove the dipstick tube and the starter motor before pulling off the oil pan gasket.