Want this question answered?
Remove the old blower wheel, then reverse the procedure.
Remove the instrument panel silencer from the passenger side of the instrument panel. Disconnect the wire harness connector from the blower motor. Remove the three screws that secure the blower motor to the HVAC housing. Remove the blower motor from the HVAC housing by rotating and tilting the motor as needed for clearance of the blower wheel....
Disconnect the negative terminal to the batter. remove the trim panel from the dash below the glove box. Unbolt the wiring bracket. DIsconnect the electrical wires and remove the 3 bolts holding the blower in. Lower it out. If necessary push the nut holding the blower wheel on and remove the wheel. Installation is reverse of these steps. Make sure electrical connectors click when you fasten them.
Hello,Here is the procedure for removing the blower unit on a 1990 300ZX. Note that it may be necessary to remove the glove box assembly to gain clearance for the blower motor removal and installation. The blower motor is located behind the glove box, facing the floor.1) Disconnect the negative battery cable.2) Remove all panels and ducting necessary to gain access to the blower motor.3) Disconnect the blower motor harness wiring connectors.4) Remove the blower motor retaining screws and lower the motor/wheel from the intake housing. On some models, release the clips that attach the blower casing to the intake5) housing to remove the blower motor.To install:1) Transfer the old blower wheel to the shaft of the new motor.2) Raise the blower/wheel assembly up and onto the intake housing. Use a new gasket, if required.3) Install the blower motor retaining screws or lock the clips.4) Connect the blower motor wiring.5) Install all ducting and panels.6) Connect the negative battery cable.7) Check the blower for proper operation at all speeds.
The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed without having to remove the instrument panel or the HVAC housing.Disconnect and isolate the negative battery cable.Disconnect the wire harness connector from the blower motor .Release the locking tab that secures the blower motor to the HVAC housing and rotate blower motor counterclockwise.Rotate and tilt the blower motor as needed for clearance to remove the blower motor and wheel from the HVAC housing.
# Disconnect and isolate the negative battery cable. # Disconnect the wire harness connector from the blower motor . # Release the locking tab that secures the blower motor to the HVAC housing and rotate blower motor counterclockwise. # Rotate and tilt the blower motor as needed for clearance to remove the blower motor and wheel from the HVAC housing. also The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed without having to remove the instrument panel or the HVAC housing.
on my 98, when you remove the compartment under the steering wheel the compartment has a diagram of all the fuses.
Inside the front passenger side wheel well (with a flashlight, you can see it through the fender vent). You have to remove the fender to get access.
i cannot get the wheel off the blower motor
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
As for why it blows only on the high speed you most likely will have a bad blower resister and for the noise, it could be a bad blower motor, bad blower wheel or trash that is stuck in the blower wheel or housing.......
The following can cause this problem.................. 1. Bad blower motor. 2. Bad blower motor wheel. 3. Trash in the blower housing...