1995-2005 Chevy Cavaliers

How do you remove the wheel on a 2002 Chevy Cavalier?

345

Top Answer
User Avatar
Wiki User
Answered
2008-12-28 21:59:48
2008-12-28 21:59:48

First you must remove the lug nuts from around the wheel, and then you must take the wheel off of the braking system

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


How do you remove and replace wiper switch on 2002 Chevy Cavalier

Remove the belt from your 2002 Chevy Cavalier alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.

Remove the inside door panel of your 2002 Chevy Cavalier. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.

Remove the tire and wheel from your 2002 Chevrolet Cavalier. Remove the brake pad springs and calipers. Reverse the process to install the new brake pads.

Steering wheels are hard to remove. A tool called a steering wheel puller needs to be used to remove the steering wheel. It removes the steering wheel by applying pressure to the middle and pulling the rest of the wheel up.

You can replace the dome light bulb in a 2002 Chevy Cavalier by first prying the dome light cover off of the light. Then, remove the bulb and replace it by twisting the bulb from the socket.

Where is the stater located on a Chevy Cavalier located?

The PCV valve on a 2002 Chevy Cavalier is located on the back of the valve cover. It is a plug in type.

You can remove the oil pan from your 2002 Chevy Cavalier, without removing the motor. The oil pan is held in place with retaining bolts.

A 2002 Chevy cavalier 2.2l needs 10.7 (qts) of silicate free antifreeze.

yeah i wonder mines 2002 Chevy cavalier and it just says "err" yeah i wonder mines 2002 Chevy cavalier and it just says "err"

Remove the wheel, caliper, and rotor (you may also have to remove the wheel bearings depending on the specific model). The wheel speed sensor is attached to the end of the wire facing the wheel hub.

all engines in 2002 cavalier have timing chains.gmjim I just purchased a 2002 Cavalier with a DOHC engine. I think that it owuld have a belt instead of a chain.

where is the daytime running light relay located on a 2002 chevy cavalier

why does my 2002 chevy cavalier over heat after i change the thermostat and the water pump

Removing the exhaust from a 2002 Cavalier is not too hard as long as no bolts are rusted. Start by unbolting the exhaust at the engine. Remove all exhaust clamps. Unbolt the pipe joints and pull the sections from under the car.

Begin by removing the wiring from the 2002 Chevy Cavalier neutral safety switch. Remove the neutral safety switch retaining screws. Reverse the process to install your new neutral safety switch.

How do youchange the clock on a 2002 zx2 ford escort?

Remove the tire and wheel from your 2002 Chevy Malibu. Remove the brake spring and the brake caliper. The brake shoes will come off. Reverse the process to install the new brake shoes.

The horn on a 2002 Chevy Cavalier is located in the front of the engine compartment. It is just behind the small air holes in the front fender on the passenger side of the vehicle.

You will need to remove the tire and wheel from your 2002 Geo Tracker. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel seal and the wheel bearing. Reverse the process to install the new wheel bearing.

How do you replace a turn signal bulb in a 1998 cavalier

Both Cavalier engines, the 2.2 & 2.4 in 2000 are DOHC.

How do I remove the rear shocks on a 2002 chevy camaro convertible?

The 2002 Chevy Cavalier 02 sensor can be found attached to the air cleaner housing. The O2 sensor will be on the back side of the air cleaner housing.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.