The 1998 Cutlass windshield washer pump fuse can be found in the fuse box. The windshield washer pump fuse will be in the first column, third from the bottom.
It's located right on the windshield reservoir...
At bottom of washer fluid tank.
To change battery on a 1998 Buick Regal, first remove the windshield washer fluid reservoir. Then remove the massive air flow housing to be able to remove the old battery and replace with a new one.
Change the pump, most likely bad. Easy to do. Find washer reservoir and remove old pump, install new one.
Replace it with new tubing.
A windshield washer pump on a 1998 Dodge Avenger ES is screwed onto the bottom of the washer fluid canister that holds the washer fluid.
lacing windshield fluid reseroir on 198 plymouth grand voyager
Windshield washer nozzles normally don't need replacing, If they are clogged, run a real fine wire through the opening to unclog them.
Windshield washer hose is attached on one end to the windshield washer reservoir pump and the other end to the spray nozzles. It is the same as every other car built in the last 50 years. --Ken
It is located right on the windshield washer reservoir. It looks like a short black cylinder.
That relay and fuse for the windshield washer should be located in the fuse/relay center under the hood.
Starting with the 1997 Ford Explorer the rear washer fluid is supplied by the windshield washer fluid reservoir in the engine compartment
It is directly below the tank that holds the washer fliud on your left side looking down. Regards, Jim
Begin by removing the washer fluid tank hoses from your 1998 Oldsmobile And tree. Remove the washer fluid tank retaining bolts. The washer fluid tank will come off.
The fuse located inside (driver's side) #13 is responsible for it.
How do I find the hose for my 1998 Toyota Avalon. It has disconneted and I need to reconnect it.
Don't remove the reservoir. You can wiggle the pump and it will come out of the reservor. You may have to remove some of the cowling underneath the car to have access to it.
The washer reservoir is located behind the passenger side head light, It is a white plastic container with a black cap, that has the washer symbol on it like the one on the steering wheel stalk.
Get a new one at a salvage yard.
On the inside of the hood disconnect the washer hose from the nozzle, and squeeze the plastic under it together. Then push it up it should come out pretty easy.
According to the 1998 Ford Ranger Owner Guide : The wheelbase on the SuperCab is ( 125.7 inches )
Near the windshield fluid washer resovior, under the speed control servo.
Remove the mirror and use a heat gun to remove the button. Caution: There is always the possibility that the windshield will crack.