answersLogoWhite

0


Best Answer

once PVC has been put together in this way it is impossible to get it apart, the primer actually melts the pipe slightly, then when glue is added it actually fusses the pieces together. The only thing you can do is to cut it apart.

Cut the pipe near flush (leave a couple of mm protruding. Now apply heat - either a heat gun - evenly around the inside of the joint until the plastic statrs to blister or paint a coat of pipe glue around the inside and set alight - hold the opening vertical to heat evenly - it may pay to hold the fitting with pliers as it gets hot in both cases.

When heated slip a small flat screwdriver down between the pipe and the fitting and pry a section away from the fitting then get a pair of pointy nose pliers in and wind up the pipe like opening a sardine can - easy as

The burning glue method give just the right amount of heat by the time the glue is spent - take care with a hot air gun as it can over heat - you only need to heat the pipe section - not the fitting as such.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove two pieces of PVC pipe that have been glued with primer and cement?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How are the fragments glued together in sedimentary rocks?

Minerals crystallize out from the water surrounding the grains and act as cement.


How do you remove something glued with loctite 330?

Just removed 20 pieces glued in the wrong place.300 degree heat,or prying from under the surface if possible.Just a heat gun helped me immensely.If heating the material is not possible whatever type of gorilla force or farm implements available.


What is rubber cement thinner?

first of rubber cement is a type of glue you can buy almost any where and well rubber cement thinner is like glue remover it makes it so you can pull apart what you glued and its good clean up for a mess you make with it.


How are glass blocks made?

They're molded in two pieces, then glued together with silicone adhesive.


Can you glue cement back together?

A lot depends on the stress factors and use that it's going to get. I've glued pieces to small concrete walls with 'thin set' cement and that works well as long as it's not subject to people jumping on on it like a step. I've also repaired edges of steps this way, but it seldom lasts a year. So far, I haven't found an actual 'glue' that works better with cement than 'thin set' .


How do you remove glued glass mirrors?

you can remove glued glass mirrors from any sort of wet sponge or you can scrape it off with a scraper. If this doesn't help I would suggest you should go ask a mirror professional.


How do you remove Astra G gearknob?

its glued on i cut mine off with a stanley blabe.


How do you remove a shift knob on a Chevy Colorado?

It is glued on you have to replace the entire stick shift


If you have ceramic tile on cement do you have to remove tiles before you can lay carpet?

If the tiles are down tight and the added height wont bother you, it is fine to go over the tile with carpet glued down or over pad. The installers will hate setting the tackstrip, but it is part of the job.. you are good to go.


What is the description of Tensol cement?

Tensol Cement joins all plastics such as perspex together permanently. The glue is applied to the surfaces to be glued and they are pressed together. They should be clamped for 24 hours.


How do you remove linoleum off a wood floor?

if it is glued with a lino paste glue,you shouldn't have a problem with the uplift. If its glued with an acrylic glue you can rent a power stripper to make the uplift easier.


Anas remembers most of her life as a mosaic made up of bits and pieces of tile that are glued together Why do you think this analogy is used to describe her past?

Usually the figures are fired in sections so they need to be glued together afterwards.