Want this question answered?
The 1997 Cavalier has two motor mounts, as well as a transmission mount. If the mounts are broken the motor can move around and cause damage to components under the hood.
in removing motor mount what bolts need to be removed. This is a 1998 biuck regal 3.8L, and I am not sure how to remove the motor mount.
the 2.2, the 2.4 and the 2.2 ECOTEC. the mount are the same for the ecos and 2.4. you just need to change the tranny, harness and fuel pump
pull it out
Loosen the motor mount retaining bolt. Jack the motor up a few inches. Remove the motor mount retaining bolt and the motor mount bushing. Reverse the process to install the new motor mount.
Use a jack with a board on top to support the engine. Loosen the bolts for the motor mount. Raise the engine slightly then take the bolts out and remove the motor mount. Install the new mount, tighten the bolts, then remove the jack.
The mount is located on the drivers side of the vehicle. remove wheel and plastic cover to access.
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
For a 99 cavalier 2.2 there are 2 mounts. The upper mount near antifreeze recovery bottle and one (dog bone) mount directly under the other, in front of oil pan. 1- transmission mount.
on the front motor mount remove lower 18mm nut loosen back lower motor mount 18mm nut jack up front part of engine then remove top bolt on frount motor mount you need a 18mm swivel scoket with a long extion remove nut then remove mount. rear would be the same way do only one side at a timeYou first have to remove the air conditioner compressor out of you way then jack up the motor, then undo the old motor mount bolts, top and bottom, then install the new mount. then put back together in reverse order.
Remove the old mount & replace with the new.
To change the starter on a 1998 s10, the motor mount will have to be removed. Support the motor on a jack with a board on the top of it, and remove the mount to get to the starter.