There is a little knob in the girls room that controls the vent
you remove the vent and hose it down. there are usually screws holding the vent in place you just have to locate them and remove them in order to clean the ven thoroughly
It controls which vent the air comes out of.
It controls which vent the air comes out of.
The W140 does not come with a transmission dip stick, you will need assistance from an auto service centre.
The vent valve is mounted on a bracket near the fuel tank. Disconnect the electrical connector. Remove the hose from the vent valve. release the retainers and remove the vent valve from the bracket. It is under the truck.
There are screws in between the slats of the vent cover.
The vent valve is mounted on a bracket near the fuel tank. Disconnect the electrical connector. Remove the hose from the vent valve then release the retainers and remove the vent valve from the bracket. Installation is the reverse of removal.
The vent control is not working. It is either electrical or vaccume. The controls are not effectiong the vents. They could also just be stuck. The vent controls are usually found under the dash. hope it helps. duboff
Well, hopefully you can locate it on the inside. Remove the clamp and hose connected to it. should be a nut on the fitting. remove the nut and vent removes from the outside. Make sure to put the proper vent back in. If it is a fuel vent it is required to have a screen in it.
It is a fault with the circuit that controls the vent for evaporative emission systems vapor. The problem could be a faulty vent valve, faulty wiring going to the vent valve, or a bad computer.
how to remove the paneling around the heated seat controls how to remove the paneling around the heated seat controls how to remove the paneling around the heated seat controls