answersLogoWhite

0


Best Answer

If you're lucky, there should be a drain plug for the float bowl (the bottom portion of the carburetor). Put a rag or something under the drain plug and then remove the drain plug, letting the gas/water flow out onto the rag. While you're at it, you may want to flush the carburetor with CRC Carburetor Cleaner, or something comparable. Give the cleaner time to evaporate, then put the drain plug back in. (Note: older outboards can have high speed needles where the drain plug should be. You can remove the needle, just make sure when you put it back in, it is in EXACTLY the same configuration it was in before. Also, DO NOT screw the needle in all the way to where it "bottoms out," as this may damage the needle permanently.)

Water in the carburetor is NEVER good, and MAY require you to rebuild your carburetor to make sure that any corrosion/gunk has been thoroughly flushed out.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove water from an outboard motor carburetor?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the water pump located on a 15HP mercury outboard?

The 15 horsepower Mercury outboard motor does not have a water pump. The outboard motor is air cooled and does not have a need for circulating water.


What color is water in the oil of your outboard motor?

White


What does a telltale do on an outboard motor?

Welcome it is a indicator that your water is circulation water correctly


How do you install a water pump on a 5 HP Johnson outboard motor?

it does not have a waterpump!


Water pump repair on a 35 hp Mercury outboard motor?

It is easy...remove the lower unit..about 5 bolts. If you want to see this done YouTube it...a lot of good videos for DIY.


Where can I find schematic of water passages in 1964 Mercury 20hp outboard motor?

try iboats.com


Can you start an outboard motor with the lower unit removed?

Depends where the water (ie coolant) intake is


How do you change a 70 HP Yamaha outboard water pump?

The water pump on an outboard motor is located low down on the skeg. To replace it, you have to remove the lower unit. The impeller water pump is a housing attached to the upper unit, surrounding the shaft. It must be replaced exactly right, so obtaining a proper servicing manual is strongly recommended.


Do boats exhaust into the water?

Boat's exhaust systems are located on the middle unit of the Outboard motor, but some of the fumes get in the water.


What to do if you run aground in an outboard boat for freeing your vessel?

Raise the motor, get out and push the boat to deeper water.


How do you remove water from lawn mower carburetor?

Take a clean rag and stuff it into the tank - it will soak up the water.


What is the best outboard motor fuel?

well considering the engine type petrol diesel the best outboard motor to get would be a petrol engine as this is easy fuel to come across just don't get any water in the fuel tank as this will cause the engine to cease and that's bad so get a petrol engined outboard motor and petrol hope this helps