To remove the water pump, first drain the cooling system and disconnect the following items: the negative battery cable, air cleaner assembly, heat shield for the exhaust manifold, feed pipe for the water pump. Then install a water pump holding tool. Remove the retaining bolts and then the water pump itself.
To change the water pump on a 2002 Saturn L200, first ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator and remove the drive belt. Next, remove any components obstructing access to the water pump, such as the engine cover, and then unbolt the water pump from the engine block. Clean the mounting surface, install the new water pump with a new gasket, reassemble any removed components, refill the coolant, and reconnect the battery.
Drain the fuel from the fuel tank. Remove the fuel line. Remove the fuel pump retaining plate. Remove the retaining plate from the fuel pump. Reverse the process to install the new fuel pump.
In the fuel tank.
locate fuel pump wiring in 2003 Saturn L200
To replace the air pump in a 2001 Saturn L200, first ensure the vehicle is turned off and disconnected from the battery. Remove any components obstructing access to the air pump, typically located near the engine. Disconnect the electrical connector and the hoses from the old pump, then remove the mounting bolts to take it out. Install the new air pump by reversing the process: secure it with bolts, reconnect the hoses and electrical connector, and reassemble any components that were removed.
Yes
tool J-43651
It's located in the fuse box in the engine compartment
The fuel pump relay on a 2002 Saturn I200 is located in the engine compartment near the driver's side. It sends power to the pump and turns it off when the vehicle is not running.
Jack up the front of the vehicle. Remove the passenger side wheel. Remove the plastic mud shield that covers the engine, there are several plastic retainer pins that should pry out with a little attention to detail. Remove the serpentine belt, or at the very least, take pressure off of it enough to pull it away from the water pump pulley. Some serpentine tensioners have a square hole that accommodates a 1/2 inch breaker bar. At that point, the water pump should be relatively easy to remove/replace.
$1000 to $2500 depending on the quality of parts and mechanic
First remove the fuel tank then remove the pump assembly locking ring then remove the pump assembly.