0
Buy a hinge pin and bushing kit then rebuild the hinge on the vehicle and avoid trying to remove the hinge off the vehicle.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
How do you remove door hinges on 1988 Oldsmobile cutlass supreme?
if there are no bolts in the door jamb then they are welded in and need to be ground down and new ones welded on
How do you remove door from a 1974 nova?
You have to drive the pins out after removing the retainer clips. The hinges are welded to the door and to the body.
How do you adjust the door hinges on a 1990 Chevrolet 1500 Pick Up?
There are no ajustments for the hinges they are welded. NEUTZ
How do you remove door hinge on mk4 fiesta?
Only the hinge pins can be replaced without major bodywork as the hinges are welded to the doors and the frame.
How do you replace lower door hings on Lincoln town car?
To replace the lower door hinges on a Lincoln Town Car, new door hinges have to be purchased. This can usually be found at a salvage yard for automobiles. The old hinges have to be cut off with a torch and the new hinges welded on.
How would you remove and replace a rear passenger door on a 1997 Chevy Suburban K1500?
the door hinges are welded so you have to use a small hammer and small punch to tap out the pins that look like big nails.
How do you remove a door from your house?
Unscrew the hinges..?
How do you remove door panel on 04 avalanche?
how do remove driver door on Chevrolet aavalnche
How do you remove the door on a 1998 ford explorer?
disconnect wiring harness, mark hinges, remove bolts securing hinges to body.
How do you adjust the doors hinges on 1989 s10 blazer 4x2?
Because the hinges are welded in place, replacing the hinge pins and bushings should restore the door back to original position.
How do you change a 2000 s10 door hinges?
Difficult job to do in your driveway. The original hinges are welded in place both on the door and the cab pillar. The welds have to be drilled out and the new hinges are bolted in. The alignment is critical. The upper hinge halfs on the body side require removal of the dash assembly. There are kits available to rebuild your old hinges while in place. The kit comes with new pins and bushings. Either way you will need a door spring compressor to remove and replace the door spring. This tool is inexpensive and can be purchased from your local auto parts store for under $20.
How do you remove a Nissan 240sx door?
Open the door, pull the pin from the stopper between the two hinges and undo the four bolts on the hinges, thats it
