You'll have to get the Robert Bentley Service Manual to show you how as it's an involved process. It's not that hard but there are a lot of pieces to put in the right order.
In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.
very carefully
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.
Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.
How to remove rear wheel bearings on a 1978 corvette..?
Remove the tire and wheel from your 2003 Kia. Remove the axle end. Remove the wheel bearing retaining nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearings.
pop them out of the wheel
Jack it up, remove the wheel, pry off the center cap, remove the cotter pin and nut, then pull the bearings out with the hub. Note that some trailer bearings are sealed and replaced as an entire unit.
Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.
they are replaced as hub assemblies, remove the wheel, remove the caliper and rotor three bolts for the hub, axle nut, abs harness if the car has it, and remove the hub assy
You must remove the wheel bearings, inspect them, repack them with grease, and install them back in the vehicle.
Front or rear?