answersLogoWhite

0

There is a "C" clip behind the handle that has to be removed. Your local auto parts store can sell you a tool for that purpose. The tool should cost aprox $5.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you Replace a radio for a 1976 Chevy Nova?

When you pull the knobs off, the remaining studs wi;ll have thin nuts on them. Remove these, and it will pull out of the back.


How do you remove the window glass of a passenger door on a '91 Chevy Suburban?

This is not an easy job. First take off the trum pad by removing the door and window knobs then all the screws you can find, then the retainers on the sides and botttom of the door. The regulator is hard to get out and there are sharp edges inside the door that can cut you badly. I suggest you take it to the auto trim shop.


How do you remove a window switch in a 2002 pt cruiser?

gently pry out evenly on surround shroud. slide red locking clip from wire bundle to release. pull off knobs and remove switch from housing.


How do you remove a shift knob on a 1983 Chevy s-10 2.8?

Most shift knobs remove by turning them counter clockwise( sitting in the truck on the drivers side). Some of these are hard to remove so use steady constant pressure when turning.


How can I replace shower knobs?

To replace shower knobs, first turn off the water supply. Remove the existing knobs by unscrewing them. Install the new knobs by screwing them in place and turning the water supply back on. Test the knobs to ensure they are working properly.


Cant turn volume all the way down on bass guitar?

Try turning down all knobs on your bass. Some basses have two volume knobs, one for each pickup.


How do you remove temperature control knobs from 2012 jeep wrangler?

A hammer.


How do you remove the headlight switch on 2008 f-250 ford?

Remove the knobs, remove the dash panel, and replace the switch.


How do you remove the stereo in a 2005 PT Cruiser?

Its actually pretty easy. Fist use small screw driver and from the bottom center pry up the power window module or face plate if you do not have power windows. Once out unplug the power window switch module and set it off to the side. Note: You will nee to unlock the connector prior to unplugging. Remove screw holding top of bezel. Next remove control knobs for heat/ac, fan speed,and hot/cold by pulling each one straight out, you me need a pair of pliers for this just be careful not to mar up the knobs. Now to remove the bezel place you hand into the opening where the power window switches were and pull. Slide your fingers around the edges and make sure you pull as straight out as possible to prevent breaking any tabs. Once Bezel is removed you remove the 4 screws holding the radio in.Tools Needed - Pliers - Small Flat & Philips head screw driverRemove Power window switches by prying up from bottomUnlock and unplug power window switch moduleRemove Screw from bezel behind power window switchesRemove all 4 control knobs (they just pull off)Pull of Bezel (Use opening made by removing power window switches)Remove 4 screws holding in radioUnplug wiring and antenna from radio


How do you remove the vent knobs on a 1974 nova?

Have the sheriff serve them eviction papers....


How do you change out all the brake lights in a 1992 Chevy Caprice Classic?

pop the trunk there's two plastic knobs,uscrew by hand and remove the bolt on top of the brakelight. pull the tail light straight out and just turn the desired bulb socket counter clockwise to remove the socket and the same to remove the lightbulb.


How do you remove a radio from a 2006 Mitsubishi outlander?

remove heater bezzel (remove knobs and remove two Philips screws.) just pull out, do not remove. then unclip and remove stereo bezzel.