At the window lever, push the door panel towards the door. If you look closely to the base of the window lever, you will see a small circular pin. That is what is keeping the window lever connected.
I removed mine by simply using a pair of long nose pliers. Just have a watchful eye as it might jump because of the spring effect.
Putting it back on is a bit trickier, but you'll get it.
To remove the window knob,you need to purchase a tool at any auto parts store, you would then slide the tool behind the window crank and simply push out the clip that holds the window lever in place.
just pull it hard out the box. If it won't come pull it and try to give it a tap out or lever it at the same time.
Computerbox location for 2001Opel Corsalite bikke 1.7 diesel
rip the car apart and get a macanic to do it
You can first try to twist it in an anticlockwise direction and then pull but if that doesnt work make a cut around the material that bonds the knob to the lever. You can then pull it out.
if its a corsa b, check behind the light switch above the fuses or behind the panel next to the bonnet lever in front of the drivers door. on some models they are even behind the fuses
Broken synchronizer, worn teeth, shift lever needs adjustment or bearings are worn.
Remove the bolt in the lever perch. For a clutch lever, loosen the cable enough to remove the broken lever and replace the new one. Adjust the clutch cable back and replace the bolt in perch. For the brake (disc brake)) lever, you simply remove the bolt and replace lever, put the bolt back in the perch and you're done. If you have drum brakes, it is the same as the clutch lever routine.
A hammer is a lever because when you want to remove a nail it helps to pry it out of the place.
Door cards. remove screw from window crank. remove the plastic insert from door, lever inside, pry. with a pry spoon , pry between lower card it goes pop, and repeat as you move. then its out. lift to clear arm rest, perch.
You can remove the parking brake lever, from the brake shoe on your Chevrolet Cavalier, by removing the retaining clip. The retaining clip connects the brake lever cable to the brake shoe.
There are 2 screws on the bottom left and right. There is one screw inside the door handle lever conpartment. There is one screw under the carpet of the door handle itself. Just in front of the window switch.After removing these screws, you can take a flat head screw driver and unsnap the left, right and bottom edges. The panel hooks to the top of the window lip. Push up and and to the right at a slight angle towards the mirror on the door. Angle the panel to remove the door lever then unplug the window switch. It's now completely off.