Take off the bolts at the bottom of the wiper arms and you may have to wiggle the arms back and forth to work the wiper arms off.
The motor is under the plastic grill that is at the bottom of the windshield. It's held in place by a bunch of plastic "rivits" that you have to remove to get the grill out.
Yes, there is a fuse for the windshield wiper motor on a 1996 Toyota Camry. It can be found in the diagram of the fuses in the maintenance manual or the owners manual.
no
Remove the windshield wiper arm from the windshield wiper motor. Remove the wiring harness. Remove the retaining nut. Reverse the process to install the new windshield wiper motor.
It is under the plastic cover right below windshield. YOu have to remove retaining clips.
It is located under the windshield cowl (the plastic cover with the holes in it, directly under the windshield). To expose it - remove the wiper arms, and the retaining nuts on the wiper shafts, then remove the screws holding down the cover.
Look around the center lower end of the windshield May have toi remove plastic cover
# Remove the windshield wiper arms # Remove the cowl cover # Disconnect the electrical connector from the wiper motor # Detach the wiper motor/linkage assembly from the cowl # Remove the wiper motor retaining bolts and remove the motor
* Remove the windshield wiper arms * Remove the cowl cover * Disconnect the electrical connectorr from the wiper motor * Detach the wiper motor/linkage assembly from the cowl * Remove the wiper motor retaining bolts and remove the motor
The wiper motor is located under the black plastic cowl below the windshield.
wiper motor arm has a small c-clip to remove and then same arm other end has a ball type that you pry off with a small cats paw type bar or screwdriver. this will remove the short wiper motor arm and then you can remove both wiper arms out thru slots in windshield frame. Be sure to remove plastic nuts on both wipers on front side of windshield frame.
The windshield wiper fluid motor is located under the windshield fluid tank. You must remove the right front wheel well cover (plastic) to expose the bottom of the tank. Remove the rubber line and the electrical connection and pull the pump out. Check the rubber o-ring to make sure that it didn't tear.