Depending on the engine ball park $700.00 to $1500.00 or higher if the heads are warped etc. There are two heads, never replace just one gasket.
If you ran your car too hot you may have warped the head which would cause your head gasket to leak water or oil. You need also to hone the heads to make them flat again.
Have a compression test run to see if you have a problem with the head or gasket. Once you find out you do, then you must remove the heads in order to determine what the problem is. Have the heads inspected at a machine shop to determine if they are warped or cracked. Once the heads are removed the gasket must be replaced so it really makes no difference.
well, first throw it away then buy a new one.
You might have the heads reworked, probably an air leak if it's over heated before and warped the heads. Very common in aluminum heads.
have you had the head gaskets replaced you might have blown head gaskets or warped heads on the block this is a costly repair check your water for oil or check your oil for water this will help to determin if they are ... have you had the head gaskets replaced you might have blown head gaskets or warped heads on the block this is a costly repair check your water for oil or check your oil for water this will help to determin if they are ...
1989-1990 240sx 1990-1997 Hard body 1990-1995 Pathfinder 1989-1995 Axxess 1990-1992 Stanza They are all the same engine.
blown Head gasket/warped heads/cracked block
No, the only permanent repair for a blown head gasket is to replace the gasket. Anything else is just an emergency repair.
if my heads are warped and gasket needs replacing what longterm damages and repairs should i expect
Warped or cracked. A machine shop can check this condition for you, it may not be visible to the naked eye.
head gaskets??? warped heads? did you have them milled?