Want this question answered?
My crock pot has a small chip on the handle. How can i repair this chip?
If the blade has a section that slides into the handle, I would use a 2 part epoxy glue on it. Instruction with the glue. If it has broken clean where the blade meets the handle, there is really not much that can be done. It can be welded, but it would always show the repair.
from the inside. take your door panel off and look around in there. the door handle is usually held on with pop rivets that have to be cut off from the inside of the door.
The dipstick is a special tool. The dealer and some transmission repair shops will have it.
Blow-by Engine showing signs of wear (rings) Try replacing PCV valve oil coming from dipstick ,means the engine is pressurizing .this is usually caused by a broken or stuck piston ring.this is a major repair
Take the seat off by unbolting it from the floorboard. Take the seat and the broken piece to a welder and have them weld or braze it back in place.
I would recommend J B Weld or Araldite for this.
My clock is in need of a repair.The workmen arrived to repair the damaged wall.The washing machine was broken beyond repair.
you will have to replace the handle, the inside door panel has to come off and then you can get to the 10 millimeter bolts that hold the handle on unless it's a 2 door and then your glass will have to be taken out of the regulator and lifted out of the back track to be able to get to the bolts, unhook the plastic clip that holds the handle rod to the latch and take the bolts out and your handle will come out.
The transmission dipstick is a special tool that only the dealer and some transmission repair shops will have.
The question you ask is too involved for a proper answer. You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
yes