You replace it. Should be next to the trans case.
where is the speed sensor on a rover 200
The speed sensor is at the back of the transfer case behind the handbrake. Series 2 can use a signal from the auto trans.
Because there is a problem with engine or gearbox etc. Limp mode was designed so you can still drive your vehicle with just enough speed to get it up on a lorry for repair.
Change the speed sensor.
Not much you can do to repair that other than replacing it.
This code indicates a problem with the vehicle speed sensor. Check the wiring and if it is good replace the vehicle speed sensor.
It is an electric speedo so it can be the speed sensor or in the speedo itself.
There are several things you can do to repair your speedometer. You can replace the speedometer cable. You can replace the speed sensor in the transmission.
how much does it cost to repair a faulty wheel sensor
try changing the vehicle speed sensor on the back of the trans
The speed sensor is located by the driver side transaxle on the transmission. 1- Disconnect the left driveaxle from the side gear shaft 2- Remove the speed sensor retaining bolt 3- Unplug the speed sensor electrical connection 4- Remove the speed sensor This is slightly more complicated than it appears. complete instructions can be found in a Haynes/Chiltons repair manual
1998 and later models are not equipped with a Vehicle Speed Sensor (on the tranny). The PCM receives vehicle speed information from the antilock brake system rear wheel speed sensor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups.