the gasket on the transmission pan has more then likely cracked, your gonna need a new automatic transmission pan gasket and you my as well get the filter too it is only 5 bucks. 14 bolts under the car, open one side first to let the tranny fluid drain and when its done dripping remove it, clean it up, put the new filter in it pops right on and off, place the gasket, and put the pan back on
The fluid is inside the transmission.
Most of them did have the auto.
may just be a transmission sensor - $20 part - start there...
If empty it will hold almost 9 quarts.
There are two speed sensors on a 1996 Dodge Avenger, an input speed sensor and an output speed sensor. Both are located on the front of the transmission.
Auto--through the dipstick tube Std. through plug in side
Ask a Loacl. HOW do you remove the dash board on a 1996 dodge avenger
i have a 96 dodge avenger 2.5 and it keeps blowing my ignition switch. any idea why?
Check: NADA.com, KBB.com, autotrader.com Reduce by the amount of $ required to repair
You can use the front bumper for a 1996 Chrysler Sebring on a 1996 Dodge Avenger.
The dashboard dude
Dodge does not use inertia or kill switches.
What ball bearing are you referring to?
There is one at each wheel.
The starter relay switch is in the same location on both the 1996 and the 1997 Dodge Avenger. The starter relay switch can be found in the fuse box.
I press my thumb firmly on the steering wheel...
The engine size is needed to answer your question.
replace it. when they go bad you can't fix them.
on the driver side in front of the wheel/ behind the bumper