answersLogoWhite

0


Best Answer

Depends on in which way they are not working / in need of repair.

See "Related Questions" below for replacing bulbs & a discussion about the brake light switch mounted at the brake pedal.

These are 2 of the most common 'fixes'.

User Avatar

Wiki User

โˆ™ 2009-10-22 03:55:05
This answer is:
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you repair brake lights on 2000 windstar?
Write your answer...
Submit
Related questions

Why is your car dying at stop lights?

what would make a 2000 ford windstar die out at stop lights and you have to put your foot on the brake and gas at the same time to keep it running and it sputters and jerks.


2000 Ford Windstar was running fine wont come out of park even when car is turned on pushing brake but still stuck in park?

First check to see if you have brake lights, if no brake lights you have a bad shift interlock switch,it is a small black box located behind your brake pedal.It's about $45.00 from the dealership. I keep a spare in my van.


What brake fluid to use in 2000 ford windstar?

In a 2000 Ford Windstar : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A ) according to the Owner Guide


Why don't the brake lights work on my Chevy Venture van 2000?

If the brake lights do not work on Chevy Venture van 2000, try to disconnect the brake switch. Then short the two contacts of the connector to check if the brake lights are now working.


What is the problem if all running lights and tail lights work but the brake lights don't on a 2000 F-250?

check the fuse, brake lights have their own, & check the brake switch at the top of the brake pedal


Where can I find an engine diagram for a 2000 Ford Windstar?

www.autozone.com click on repair info :)


What fuse controls the brake lighta on a 2000 dodge caravan. all lights work except no brake lights when pedal is pushed?

Check the brake light switch on the brake pedal


What is wrong if the brake lights in a 2000 Cavalier Z24 do not work but the tail lights directional hazard and center brake lights all do and the tail lamps have been replaced?

Check the brake switch at the pedal.


How do you repair dtc p1405 on 2000 ford Windstar?

usually that code is a hose off or cracked


How do you put the third row seat up in a 2003 Windstar and make it stay?

How do I repair my third row seats in my 2000 windstar that will not stay up properly.


How do you fix the brake lights on a 2000 Ford Contour that stay on while the car is off?

check the brake pedal, there is a switch on the back of the pedal that depressed when the brake is depressed that turns the lights on, when this is loose it keeps the lights on.


How do you replace the brake lights on a 2000 dodge stratus looked inside and do not see how you can get to the brake lights?

Often these are accessed thru the trunk; have you tried that?


What causes a battery alarm in a windstar 1996?

I had the same issue on my 2000 Windstar, until one day I noticed my brake lights stayed on after I left the car. Turns out the brake lights left on all day drained the battery. To fix this I went under the dash and removed the cotter pin that holds the brake peddle on, then I unplugged the brake switch and pulled it out. Inside the box is a simple on-off contact switch that is activated when you press down on the brakes. Bending the copper contact arm up a little fixes the issue. Just put everything back together and check that your brake lights come on when you step on the brake! I hope this is your issue, other wise you have another short somewhere. Trevor trevor is right about the brake lights being a cause for the problem. But, it could also be a 12 volt negative short that is draining the battery. that is what happened to a friends car. it would drainb the battery over night


What should you do when the brake light comes and goes in a Windstar 2000?

check the brake fluid level. try filling to top. Get it fixed !


What would make the brake lights work on a 2000 dodge 1500 van?

If you mean the brake lights are stuck on, then check the stoplight switch located on the top of the brake pedal.


Ford windstar 2000 speedometer and odometer stopped?

Start with the vehicle speed sensor the feeds the speedometer and odometer.Also look at the Brake/Speedometer problem associated with the Windstar recall for a leaking brake pressure switch


Center brake light works side brake lights do not work 2000?

its gotta be a ford a problem with the center brake light circuit causes the lights to go out i believe it is a diode


How do you turn on cornering lights on 2000 ford windstar?

The cornering lights are tied in with the turn signals - they'll come on automatically IF the turn signal is used.


What do you check when 2000 jeep wrangler brake lights do not work?

fuse, bulbs, switch on brake pedal.


When it rains why does our 2000 Ford Windstar LX brake lights stick on when turned off This is a pain because it drains your battery and then you need a boost Any ideas as to why they stay on?

Sounds like you may have a defective relay, which is in the fuse box. It is worth checking out.


How do you replace rear windshield in 2000 Ford Windstar?

Heat cut the windshield out, just make sure not to damage the brake lights, and the windshield wiper, fit the new glass to the back, and weld it on the inside after removing the fabrication, put the fabrication back on, make sure the brake lights and windshield wiper work, and if they do, you're good, if they don't, visit an inspection shop, they'll hook ya up.


What fuse is the brake lights on 2000 ford expedition?

The left brake light works the right brake light doesn't and the bulbs is good


Why doesnt your brake lights work on your 2000 dodge neon?

Bad fuse or bad brake light switch.


What is the problem with a 2000 jeep grand Cherokee that the brake lights work fine when the lights are not on but when the lights are on the brake lights don't work?

replace the lamp socket they short in a strange way, it happened to me 3x. the socket carbonized from bulb heat


How do you reset the ABS and brake lights on a 2000 Toyota MR2?

To reset the ABS and brake lights on a 2002 Toyota MR2, trying disconnecting the battery for 10 minutes. A Toyota dealer can also reset the lights.