Remove the transmission.
Take out the battery tray and remove the starter. Unhook the clutch cable and remove the bracket. Take out the speed cable and unplug a couple wire harness's. I removed hood of vehicle so i had more room. Support motor with a jack. Unhook the stablelizer bar and gear shifter. Put a jack under trans and crossmember. Unbolt the transmission and crossmember and it's ready to drop. Time your looking at 4 hours.
Their is no such thing as a free repair manual, Check with your local library and see if they have an auto repair manual that you can check out.
Major repair requiring the removal of the transmission. Considering you ask the question, you are not qualified to perform this repair.
how do you change the engine oil and oil filter on a 96 ford aspire
How do you change a fan clutch on a 1991 bmw528i?
Take it to a professional and have the SRS repaired. He will reset the light after the repair. Not a DIY repair.
The clutch is hyraulic meaning there is no adjustment....If the pedal releases low replace the hydraulic unit If it's high you need a clutch You can't tighten the clutch you have to change it.
take it to a repair shop
With engine oil filter change ( 3.6 quarts ) according to the Owner Guide
no just remove the belt then the bolt that holds the clutch on dont loose the shim and make shure the air gap is correct.
where do you add clutch fluid on a Mazda 1997
Autozone.com has a place called "my zone", once you log in they have repair manuals you can look through.
According to the 1997 Ford Aspire Owner Guide : With engine oil filter change ; The 1.3 liter / 81 cubic inch four cylinder engine takes : ( 3.6 U.S. quarts / 3.4 liters of PREFERRABLY 5W-30 )
how to remove a clutch out of a transmition on a 1997 dyna wide glyde
Not on the clutch itself but on the clutch pedal there is one for starting.
I thought 1997 was the last year they made the Ford Aspire.
It is a hydrolic clutch does not need adjusting
Replacing the clutch slave cylinder requires removing the transmission assembly. I would recommend purchasing a shop repair manual for that vehicle if you intend on DIY.
On a 1997 Ford F-250 : The manual transmission clutch is hydraulic
Preferably bolted to the engine!
this site^ will show you a how
you can go to nada.com and you can find out.
It probably has a hydraulic clutch so you will have to bleed the air out of it.