How do you repair power door locks on a 2001 Hyundai Accent?
There is not a specifically designated fuse for the power locks on the underdash fusebox label. The power locks are actually on the sunroof fuse (#15), whether or not the car has a sunroof. Check that fuse and replace if necessary.
If the overdrive of a 1998 Accent Hyundai does not kick in because there is no power going to the solenoid where does the power come from?
From the PCM. You'll need a repair manual to determine which wires to test
Yes, power steering comes standard in a hyundai accent, If you really want to be sure, look in the engine bay for a "POWER STEERING FLUID" receptacle.
The 2004 Hyundai Accent is 5 ft. 5.7 in. (65.7 in.)12V front power outlet(s) wide.
The 2010 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2008 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2013 Hyundai Accent is 5 ft. 6.9 in. (66.9 in.)1 one-touch power windows wide.
The 2006 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2002 Hyundai Accent is 5 ft. 5.7 in. (65.7 in.)12V front power outlet(s) wide.
The 2003 Hyundai Accent is 5 ft. 5.7 in. (65.7 in.)12V front power outlet(s) wide.
The 2009 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2011 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2012 Hyundai Accent is 5 ft. 6.9 in. (66.9 in.)1 one-touch power windows wide.
The 2001 Hyundai Accent is 5 ft. 5.7 in. (65.7 in.)12V front power outlet(s) wide.
The 2007 Hyundai Accent is 5 ft. 6.7 in. (66.7 in.)12V front power outlet(s) wide.
The 2014 Hyundai Accent is 5 ft. 6.9 in. (66.9 in.)1 one-touch power windows wide.
its only a small engine??
ATF B2, dextron 3, 4 or higher
Break it off or remove with large wire cutters
In the back of a Haynes repair manual or autozone.com there you will find online repair manual's
left side of the engine bay kind of a yellow color its labled on the lid
When you press the brake pedal on your Hyundai accent there sounds like air escaping from under the dash but goes away when brake pedal released?
The power brake booster is bad.
How do you fix a Hyundai Accent 1500cc fuel injection engine that stutters and has no power when cold as if the air choke is not functioning?
The coolant sensor for the ECM is malfunctioning. Get a manual on your car to find where it is located.
How do you repair the power vacuum locks on an 82 Mercedes 380SEL and how much should it cost to have them repaired?
It depkends on what is wrong with them for both questions. Also the cost of repair depands on the area of the country you live in. Call a couple of local garages for estimates.
How do you repair the power locks on a Chrysler Town and Country that make a sound like a grrrrrrrrrr when you reach speed to activate them?
The lock actuator will need replaced in the door that makes the sound.
how to improve a weak motor on a 2000 Hyundai accent These engines are very prone to losing power if the plugs are not gapped correctly. So, if you have 100,000 miles or so on the engine start with new plugs. As you remove the old plugs check them to see if they are a clean grey color indicating that they are firing correctly. If the plug is black it means you have a bad… Read More
First check the fuse. Second check the switch. Same goes with power windows. A weak motor will melt a switch. If that fails ,connect a 12v power supply strait to the door in question.
PCM, Relays, Power locks, wiring
Lets say you go 52 miles on a full tank of gas (which is a 8 gallon tank). The gas tank will lose a quarter tank of gas from the trip. So, 52 divided by 2 =26. The trek was both highway and city combined. The Hyundai Accent is getting 26 mpg, not 40, which was the reason Hyundai reimbursed purchasers of the Accent in the form of a debit card to make up the… Read More
What is wrong if the power door locks aren't working and you have to push the button many times for them to lock or unlock?
U need 2 spray the inside of the power door lock switch with electrical contact cleaner or repair the loose connection on the back of the switch
The power steering pump on an automobile will not air lock. If the power steering is not working properly, it could be that the pump itself is in need of repair. Replacing the power steering belt might also fix this problem. Also check to make sure the pump has enough fluid to operate properly.
If the power door locks quit working on a 1979 Corvette, it is due to broken pigtail switches. With age and use, the pigtails break and leaves the power door locks inoperable.
Why would 94 Hyundai Excel drop power suddendly for a second then rev excessively and engine light come on?
If it is doing that, it means you have a blown transmission. You need to take it to the repair man immediatly
Remove the power locks and windows fuse you will loose power for your windows also
Power locks on Ford E-150 Econoline Vans? If the van was ordered with power locks, they would be installed. Some owners don't want them and they can be ordered without. joedi
Reading through my Haynes repair manual. It seems theres a circuit breaker (NO FUSE) for power windows/locks. My manual said its right next to the fuses, but I cant find it myself, thus im looking for a answer on this forum
Not necessarily. Keyless entry will have power door locks, but not all power door locks are coupled to a keyless entry system.
not completly sure but if its like the earlier ones then there are 4 3 visible 1 not the visible ones are for the power steering pump, water pump, and the oil pump the nonvisible one is the timming belt for the engine.
well one if your running a after market radio or subs its pulling to much power find a higher fuse that will fit in that spot but no more then 2X the one that came stock!!
Where are the tach-RPM wire dimmer wire and power wire cables on a Hyundai Accent GL 1.6 hatch DOHC that an aftermarket tachometer connects to if the car does not have a factory installed tachometer?
this depends on the year, that will determine the type of ignition and the conection.
In a Honda Integra, you can convert manual locks to power locks. You can either purchase a kit and do all the wiring yourself, or you can purchase doors from a junk yard and redo the kit. By purchasing doors, the wiring is already set up.
it could be ...check fuse 15 it controls ur power locks
It can have power locks with out keyless.
Why do the power seats work but the power door locks and the cigarette lighter do not on a 1997 gmc surburban?
They (the locks and the lighter) are on the same #13 fuse, along with the power lumbar support motor.
Power steering fluid should always be used in the power steering. Years ago, some vehicles did use ATF in the power steering but that was limited to a few domestic vehicles..1930fcoupe Use exactly what your owner's manual lists. Some vehicles require a special fluid, such as Honda. Using an incorrect fluid could cause damage. If you don't have an owner's manual, call a Hyundai dealer to be sure. Don't just guess.
Use Hyundai SPIII in transaxle and power steering system.
power door locks don't work on my 1997 Honda crv
If the door locks and power seats stopped working at the same time and the fuses are good on a 1996 Toyota Avalon how can you repair the problem?
honestly the best thing you could do is get a new vehicle. Models that old that have power windows/locks are screwed once they stop working..... cheaper to just get a new car Since you say they all went out at the same time, it is unlikely that it is a failure on the locks or window motors themsevles but it sounds like there is a bad wire somewhere...you would have to take it to a… Read More
Most likely a broken wire in the hinge area of the door. Here's how to remove the trim panel http://www.ricksfreeautorepairadvice.com/uncategorized/remove-a-door-trim-panel-from-any-vehicle%E2%80%94-without-a-diagram Here's how to test the window motor http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
The driver door does not unlock the power locks for a few reasons. This motor could be burned out or the wires could not be attached correctly.