answersLogoWhite

0


Best Answer

It is on the same circuit as the brake lights, but if they are not working, and the bulbs are good your switch needs cleaning or adjustment.

Attempt this first since the switch costs nearly $300 bucks.

On the passengers side of the trans just behind the bell housing there is a fan shaped switch, loosen the 12mm bolt ( smaller of the two, and rotate the switch while a friend checks the lights. this problem is usually accompanied by an occasional inability to start the vehicle, but can be cured by jiggling the shifter.

While adjusting the switch make sure that the vehicle will start in park as well, remember to block the wheels while testing the back up lights, engine off, key in run but not start, shifter in reverse, move switch until lights come on.

Once you find this spot, hold it in place and have your helper check to make sure it will start. This may take several tries to get both working correctly.

If you have no luck the switch may be dirty, this happens a lot. Hold the post to the bottom large bolt still while you loosen the nut, then remove it, then remove the 12mm adjusting bolt on top, remove the wire connector and pull the switch away, remove the bolts on the switch and separate the halves, use electrical contact cleaner and maybe some q-tips to clean all the copper connections completely apply di-electric grease and reassemble, refit to the trans and readjust so all functions work, this switch controls back up and start safety.

Caution! always hold that bottom bolt while tightening the large nut, this is connected to the gear adjuster and you could damage the internals if it isn't secured while you do it.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you repair reverse lights on a 1989 Jeep Cherokee?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the reverse light switch on a manual 1989 Dodge Colt?

this question should be listed under automobile repair


How do you repair tail lights on a 1989 F150 We have changed the bulbs and fuses?

Does it have trailer light wiring also? check that too.


Are the parts of a 1985 or 1989 Jeep Cherokee compatible with a 1990 Jeep Cherokee Pioneer?

That depends on what size engine you have. HOwever, most Jeep Cherokee/Grand Cherokees had compatible parts from 1984 to 1998(1). (1)Chilton Repair Manual


How do you replace head gasket in a jeep Cherokee 1989?

I would suggest purchasing a shop repair manual for that vehicle if you intend on doing the job yourself.


How do you replace spark plugs in a 1989 Cherokee?

How to replace spark plugs in a 1989 jeep cherokee?


Why would the brake lights work on a 1989 Jeep Cherokee but tail lights and console lights do not work?

Console lights and brake lighting are on different circuits (Fused seperately). Check the following: bulbs, bases, corroded connections, poor ground, blown fuses, faulty light switch.


Why do I have no running lights front or back and no tail lights- head lamps signals and flashers work fine-1989 Jeep Cherokee Laredo?

Your Electronic Ignition Switch is bad. It is located on the inside of the jeep under your steering column.


How do you repair the shifter that will not move out of park on a 1989 Ford F150?

it's got a shift interlock.check brake lights if they work check interlock switch


What do you do if your 89 Nissan Sentra clutch pedal quit working and you could not get it in gear but you forced it into reverse and now it is stuck in reverse.?

If a 1989 Nissan Sentra clutch pedal quit working and the car is now stuck in reverse, it will need to be towed to a repair shop to fix the clutch. The transmission may also be damaged due to it being stuck in reverse.


Are there AIR bags in a 1989 Jeep Cherokee Pioneer?

No.


Adjust timing on 1989 Jeep Cherokee?

It is self adjusting on a 89 Cherokee with a in line 6 4.0


What does the differential do in a 1989 Jeep Grand Cherokee and what happens if it doesn't work and or go out?

Please, rephrase the question. You say you have a 1989 Jeep Grand Cherokee, but the Grand Cherokee did not come out till late 92, but was considered a 93 model. If what you really have is a 1989 Cherokee, we need to know the motor size. The rest we can look up and give you the best answer possible.