answersLogoWhite

0

It depends. If the sensor is working, just reset the computer. Otherwise you have to change the sensor.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Map light replace bulb in 1996 Toyota Camry?

To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.


Map sensor hose is connected to what?

what hose connects to the map sensor on a Toyota Camry


Can you clean a map sensor Toyota Camry?

Usually map sensors have to be replaced and cannot be repaired.


When was Map of the Human Heart created?

Map of the Human Heart was created in 1993.


Why does replacing the bulb in the dome light of my 1995 Camry not fix it?

Check the fuse box under the hood next to the battery. The lid will map the location of the 20A fuse for the dome light. Don't be surprised if the radio and/or clock goes out when you pull it, but should work OK when its replaced.


Where can you find a fuse box map for a 1993 Mazda 929?

WHERE IS THE FUSE BOX IN MY 929 MAZDA AND WHERE. HOW DOES THE ENGINE CHECK LIGHT LOOK AND LAST WHY IS IT ON AND STILL RUN


Where are the manifold absolute pressure sensor and the throttle position sensors located in a Toyota Camry?

on a 1992 Camry the map sensor is attached to the center of the firewall by a bracket and has a rubber vacuum hose connected to it.


Where is the MAP sensor on a 2000 Toyota Camry 4-cylinder?

It's attached to the firewall next to the throttle body.


Where is a map sensor found on a 1996 Toyota Camry?

Backside, center of engine block right below the intake manifold.


How do you repair a broken retractable wall map?

Buy a new one


What does it mean for a 1993 GM Sierra when the light flashes three times and then stays on for a pause and repeats?

according to my manual 3flashes,pause,3 flashes deals with the map sensor........check the vacuum hoses from map sensor.check the electrical connections to the ECM. Replace the map sensor. Hope it helps good luck!


Where is map sensor location on 1993 dodge 5.9l turbo diesel cummins?

No such part on a 1993 Cummins