Just yesterday I replaced the door check on my 07 Eclipse GT:
Buy the replacement part (~$35 at the dealer)
Tools needed: 10mm socket (w/ 6" extension - a plus), 10mm open-end or box wrench, phillips screwdriver
Detach door check end from body frame
Remove door panel from door frame, disconnect wire connector from switches
Remove speaker from door frame
Put arm in speaker hole and hold onto door check, do not allow loose parts (if any) to fall into bottom of door, near-impossible to retrieve.
Unbolt door check from door frame, remove from door.
Install in reverse order.
Recommend not to do final tightening of all door check bolts until both ends have been bolted into position, then tighten the four bolts but do not over-tighten as the threads easily strip.
open the door, remove door trim and the torque screw holding the strap to body, and two nuts holding strap to door and remove door stop from inside door
How do u replace a hood release strap on a Mercedes c230
This is rather simple actually. You light the entire car on fire! Hope this helps.
there good if you strap 15 canisters of propane to it and then throw a baby at the propane canister
A low battery can make the starter crank slowly. Another thing that can cause this is bad grounding. Check the ground strap(s) from your motor to your chasis. Unfasten it at each end and clean the connectors and the area where the strap connects. Make sure the strap(s) are not overly frayed. If it is replace it.
Yes you need to at least replace the one that is broken and check out the other one and see that it might need to be replaced!
Unbolt it and buy a new one
you start off by dipping the ball in blue you then put on the thin strap, then color it purple, take off the thin strap and replace it with the big strap then die it blue, take off the big strap and your done! 😄
It maintains the door position when you leave it ajar.
The battery in an Alfa Romeo 147 it held in place by a strap. This strap is not adjustable and therefore it is critical to replace the battery with one that is exactly the same size.There is a great step-by-step article on how to replace the battery here:http://www.ambor.com/public/gtabattery/gtabattery.html
Try oiling the hinges on the door. Replace the check strap. That is the part between the two hinges.
To replace a roller shutter strap by yourself first read the accompanying instructions that came with the new part. The instructions state that the shutter should be in the open position. The old shutter strap should be carefully removed from pulling from the top. The new shutter strap should then be placed in the same position where the old shutter strap was removed from.