0
How do you replace EGR valve or clean it on 1997 Dodge Avenger?
Wiki User
∙ 10y ago
Replace if failed.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Can you use 97 Dodge Neon heads to replace heads on a 98 Dodge Avenger both are 16 valve and DOHC?
yes. they both use the 420a motor.
Where is the iac valve on your 1995 dodge avenger?
next to the tps
Where is the PCV valve located on a 1995 dodge avenger 2.0 4-cylinder?
On the valve cover
Where is the short runner valve on a 2008 dodge avenger?
is it on the side of the intake
How do you you replace a valve cover gasket on a 1995 Dodge Intrepid?
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.
Wher is the intake manifold runner control valve on a 2008 Dodge Avenger?
Finding the intake manifold runner control on a Dodge Avenger is easy. It is located near the engine.
How do you clean the EGR valve on a 2005 Dodge Grand Caravan?
Just replace it, the sensor on the top of it is usually what goes bad.
How do you replace the heater control valve on 99 dodge ram?
A 1999 Dodge Ram does not have a water control valve.
What causes the rpm to fluctuate on a 98 dodge ram 1500?
it could be a bad egr valve....either remove and clean, or just remove and replace....you can clean it with carb cleaner, but they arnt too expensive to just replace instead
How to replace egr valve in 98 dodge 1500?
A 1998 Dodge Ram does not have EGR.
How do you change or clean an EGR valve on a 1997 Dodge Avenger 2.5L V6?
The EGR it's in the back of the Manifold. It may not get clean, you need to replace it. You would have to take the manifold off and when you do so remember where were the vacum lines. If you can do it or looks like it gets to difficult for you, it is better to reconnect everything back and take it to your macanic. It's shure a kind of difficut if you have never take off the manifold.
How do you install a PCV valve on a 1997 dodge avenger 2.0L?
It's basically a "plug-and-play" installation. Simply pull the hoses off the ends of the current PCV and replace it with the new PCV. Replacement is reverse of removal.
