answersLogoWhite

0

How do you replace a 2000 Ford Taurus driverside fender?

Updated: 10/22/2022
User Avatar

Extinguisherman

Lvl 1
15y ago

Best Answer

remove headlight there is 2 bolts there ,remove enter fender there is one nut that bolts the bumper to the fender,there is two bolts at the bottom of the fender next to the door.then one bolt in the middle of fender next to the door. then you got the bolts on top of fender under hood

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a 2000 Ford Taurus driverside fender?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the battery on a 2000 Chrysler Sebring?

AnswerThe battery located inside wellwheel on driverside, turn wheel all the way to the right open the well wheel cover,battery inside fender comparment.


Where is the throttle positioning sensor and how hard is it to replace on a 2000 Ford Focus ZX3?

i think, but don't hold me to this, on the driverside just below the air filter box. postioned to the torqconverter case next to the tranny. u can see a throttle cable attached to this position sensor if i am not mistaking this to a taurus...


How do you replace heater core on 2000 Ford Taurus?

I am very sorry. I was under the impression that if I go to the address bar and ask a question. The answer would be right forecoming. I only asked how to replace the heater core on a 2000 ford taurus. And received only run-arounds.


Is a transmission for a 2000 Taurus compatible with a 1998 Taurus?

No. 2000 Taurus and Sable are the only interchange.


Are there daigrams to how to replace 2000 Ford Taurus headlamps?

Yes - in the Owners Manual.See "Related Questions" below for more


Where is the fuel pump relay location on 2000 Chevy?

There is a big black box on the driverside inner fender well by the battery, remove the top off of it, flip lid over and read and you will see were the relay is. It is in that box. ( electrical center )


How do you change the pcv on a 2000 grand vitara?

Look to the rear of the driverside valve cover. You will see if at this entry point. Remove the hose and simply pull it out and replace it with the new one.


How do you replace the ignition coil on cylinder 3 on a 2000 Ford Taurus?

if it is a dohc engine then you may have to remove the intake manifold


Where can you find the belt diagram for a 2000 Ford Taurus?

AnswerThere may be a sticker under the hood somewhere that shows the routing of the belts. I can't swear about a 2000 Ford Taurus, but other Fords have this sticker. It might be over the radiator, or on the fender wells, or on the hood itself. They used to be silver with black printing. Look around. Good luck.


How do you deactivate your antitheft on a 2000 Ford Taurus se?

how do i deactivate factory alarm on 2000 ford taurus


Is there a fuel pump fuse on a 2000 Tahoe?

Open the hood and on the inner fender well driverside is a big black box that has electrical center wrote on the top. remove the top and flip it over and read the inside of it. It will show you the fuel pump relay and fuse location.


What type transmission fluid for 2000 Ford Taurus?

The transmission fluid for the 2000-2004 Taurus is MERCON V.